POSIFLEX PP2000 - Manuals

POSIFLEX PP2000 – Manual in PDF format online.

Manuals:

Manual

Manual POSIFLEX PP2000

Summary

Page 3 - Table of Contents

PP2000 (E) User’s Manual i Table of Contents PRODUCT BRIEFING . . . . . . . . . . . . . . . . . . . . . . 1 -- 1 MAIN PARTS ON THE EXTERIOR . . . . . . 2 -- 1 OUTPUT AREAS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 -- 1CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 4 - REGULAR MAINTENANCE PROCEDURE

PP2000 (E) User’s Manual ii STORE STAMP (OPTION) . . . . . . . . . . . . . . . . . . . . . . 6 -- 4INTERNAL SWITCHES . . . . . . . . . . . . . . . . . . . . . . . . 6 -- 4CASH DRAWER CONNECTOR . . . . . . . . . . . . . . . . . 6 -- 5SERIAL INPUT CONNECTOR (STANDARD 9 PIN RS232INTERFACE) . . . . . . ...

Page 7 - II. MAIN PARTS ON THE EXTERIOR; OUTPUT AREAS

PP2000 (E) User’s Manual 2 - 1 II. MAIN PARTS ON THE EXTERIOR A. OUTPUT AREAS B. CONTROL PANEL Receipt exit slot Journal window Validation printinginsert slot PowerLED On line LED PowerOn/Offswitch Receipt switch Journalswitch Manualstampingswitch Receipt LED Journal LED On line switch

Page 8 - INPUT / OUTPUT CONNECTOR

PP2000 (E) User’s Manual 2 - 2 C. INPUT / OUTPUT CONNECTOR Cash drawerconnector Serial connector Power connector Parallel connector

Page 9 - CHECK CONTENTS; OPEN TOP COVER

PP2000 (E) User’s Manual 3 - 1 III. INSTALLATION A. CHECK CONTENTS When you unpack carefully the carton that delivers PP2000 series printer, you will find it contains several items as illustrated below. l l PP2000 2 - station receipt / journal printer l l Two rolls of paper roll sample l l One set o...

Page 10 - STORE STAMP

PP2000 (E) User’s Manual 3 - 2 C. STORE STAMP INSTALLATION If your printer comes with stamp option, you can find a store stamp case in the rear of the receipt part of print anvil assembly. Youmay take it out gently by holding its handle with your fingers. Disassemble the holder and the spring piece ...

Page 11 - RIBBON

PP2000 (E) User’s Manual 3 - 3 of store stamp. When the printing ink of the stamp is not enough, you can drip printing ink into the two holes in the rear of the stamp case. D. RIBBON INSTALLATION / REPLACEMENT When replacing the ribbon, please take the handle at the center of the old ribbon case and...

Page 12 - CASH DRAWER CONNECTION; CONNECT TO HOST COMPUTER; POWER CONNECTION

PP2000 (E) User’s Manual 3 - 4 turn the knob of the ribbon in the marked direction to tighten the ribbonand to ensure proper operation of the ribbon and to avoid jamming. E. CASH DRAWER CONNECTION Using the Posiflex signal cable CCBLA-180 to control a Posiflex cash drawer (CR3100 or CR3200). However...

Page 13 - POWER ON; PAPER ROLLS INSTALLATION

PP2000 (E) User’s Manual 3 - 5 H. POWER ON Turn on the On/Off switch at the left to the control panel, there will be a short buzzing sound and it indicates a normal power on. I. PAPER ROLLS INSTALLATION 1. Please refer to the picture above: Put the receipt roll into the leftpaper roll compartment an...

Page 14 - SELF TEST; REPLACE TOP COVER

PP2000 (E) User’s Manual 3 - 6 4. To give an idea about the positioning matter of the receipt, the printcenter is 33.3 mm behind the auto-cut position, whilst the stampcenter is 40.0 mm behind the print center. J. SELF TEST Please power off the printer for at least three seconds and then press and h...

Page 15 - IV. MAINTENANCE NOTICES

PP2000 (E) User’s Manual 4 - 1 IV. MAINTENANCE NOTICES l The printer should be put at a well ventilated site and avoid directsunshine, also avoid high temperature, high humidity, highmagnetic field. The site should also be free from lots of metal chipsand dust. l Never place any vessel for water alc...

Page 20 - LED INDICATIONS; BUTTON FUNCTIONS

PP2000 (E) User’s Manual 6 - 2 C. LED INDICATIONS Power LED: Green: Printer power is workingOn line LED: Green: Printer is at on line state. The printer takes command from the host system at this state andtakes no command from the buttons. Receipt LED: Red: Receipt paper is out, or malfunction with ...

Page 21 - PRINTER GENERAL SPEC

PP2000 (E) User’s Manual 6 - 3 E. PRINTER GENERAL SPEC ITEM SPECIFICATION Functions Receipt, journal and validation printing Printing Method 9pin dot matrix impact; synchronized orseparate printing of receipt and/or journal Printing Speed About 3 lines/sec., bi-directional Printing Capacity Receipt:...

Page 22 - INTERNAL SWITCHES

PP2000 (E) User’s Manual 6 - 4 F. STORE STAMP (OPTION) Cushion width: 34.0 mmCushion height: 24.0 mmCushion thickness: 1.0 mmCushion material: PE foamStamp total width: 34.0 mmStamp total height: 24.0 mm (engraving included)Stamp total thickness: 5.0 mmEngraving width: 30.0 mmEngraving height: 20.0 ...

Page 25 - DAILY MAINTENANCE

PP2000 (E) User’s Manual 7 - 1 VII. REGULAR MAINTENANCE PROCEDURE A. DAILY MAINTENANCE Perform a basic cleaning and maintenance daily at a suitable timing as following 1. Turn power off and open the top cover.Press down the receipt lever and thejournal lever. Take out both the paperroll of receipt a...

Page 26 - PERIODIC MAINTENANCE

PP2000 (E) User’s Manual 7 - 2 B. PERIODIC MAINTENANCE A periodic maintenance and lubrication should take place by a qualified maintenance specialist in every 6 months.

Page 27 - VIII. BASIC TROUBLE SHOOTING; NO OPERATION; AFTER POWER ON

PP2000 (E) User’s Manual 8 - 1 VIII. BASIC TROUBLE SHOOTING A. NO OPERATION AFTER POWER ON If the printer does not work, neither does the power on LED lit:1. Check if the power cord is well connected. 2. Check if the power outlet the printer is connected to is suppliedwith power. 3. If the printer d...

Page 28 - PAPER JAMMED

PP2000 (E) User’s Manual 8 - 2 D. PAPER JAMMED In case of serious paper jammed problem, please pull both the receipt lever and the journal lever forward and push the print anvilassembly backward (as indicated in the picture) to raise the print anvilassembly. Receipt lever Journal lever Raise theprin...