Page 2 - Content
Content Operation Instructions ................................................................................................................................................... 1 Unpacking Instructions ...................................................................................................
Page 3 - Operation Instructions; Reorient or relocate the receiving antenna.
Operation Instructions Thank you for purchasing the PXL2471MW LED LCD monitor. Please read this guide thoroughly before installation. FCC RADIO FREQUENCY INTERFERENCE STATEMENT WARNING: (FOR FCC CERTIFIED MODELS) This LED LCD Monitor has been tested and found compliant with the limits for a Class B ...
Page 4 - Avertissement de la FCC:; doivent être utilisé pour être conforme aux limites d’émission.
COMMUNIQUE D’AVERTISSEMENT DE LA FCC CONCERNANT LES INTERFERENCE DE FREQUENCE RADIO: (SEULEMENT POUR MODELES CERTIFIE PAR LA FCC) Ce moniteur a été testé et à été trouvé conforme aux limites pour un appareil numérique de Classe B, suivant la partie 15 des règlements de la FCC. Ces limites ont été dé...
Page 6 - Consignes de sécurité
Consignes de sécurité Respectez tous les avertissements, les précautions et conseils d’entretien recommandés dans ce manuel de l’utilisateur pour maximiser la durée de vie de votre appareil. A faire : Éteindre le produit avant de le nettoyer. La surface de l'écran tactile peut être nettoyée avec un ...
Page 7 - Package Overview
Package Overview LED LCD Monitor Base Power Cord VGA Cable Display Port Cable Audio Cable User’s Guide 5
Page 8 - First Setup; Install the stand base; to remove the screw that holding your monitor to the base.
First Setup Install the stand base 1. Lay the LED LCD Monitor flat on a table with the LED screen face down. To prevent the LED LCD Monitor from being scratched, put a piece of soft cloth on the table on which the screen will be set. 2. Unpack the base, one hand hold the monitor, the other hand to p...
Page 9 - Front View of the Product; Input select/ Confirm Selection
Front View of the Product ① ② ③ ④ ⑤ ⑥ ① OSD Turn On/ Off ② Scroll Down/ Adjust Decrease/ Audio Adjust/ Auto * ③ Scroll UP/ Adjust Increase/ Picture Mode * ④ Input select/ Confirm Selection ⑤ Power On/ Off ⑥ LED Indicator * Hot keys Instructions please see “Using the OSD Menu” on page 10. 7
Page 10 - Rear View of the Product; Power Input
Rear View of the Product ① ② ③ ④ ⑤ ⑥⑦ ① Power Input ② Cable Management ③ DisplayPort Input (DisplayPort 20 pin) ④ HDMI input (HDMI 19 pin) ⑤ VGA Input (D-Sub 15 pin) ⑥ Audio Input ⑦ Headphone Jack 8
Page 11 - Quick Installation
Quick Installation 1. Connect either VGA, HDMI or DisplayPort Video Source from the monitor to the computer. Make sure both monitor and computer are powered OFF. Please note. The monitor ships with DisplayPort and HDMI cables only. VGA cable may be sourced separately from a cable supplier. 2. Connec...
Page 12 - Basic Operation and Calibration/Reset Instructions; Using the OSD Menu
Basic Operation and Calibration/Reset Instructions Before using the LED LCD Monitor: Connect external equipment properly. Insert the power plug, and the power LED indicator will light orange. Power On/Off To turn the LED LCD Monitor on/off: Press button on the front. The power LED indicator light wi...
Page 14 - Advanced Operation—OSD Menu
Advanced Operation—OSD Menu You can use the OSD menu to adjust various settings for your LED LCD Monitor. Press the 1 button to display the OSD Menu, and use ▲ or ▼ to select the desired OSD menu. Short Cuts Function from the button(s) AUTO IMAGE ADJUST: To auto adjust Horizontal Position, Vertical ...
Page 15 - MANUAL IMAGE ADJUST:
INPUT SELECT: When Input Select is pressed, change Input signal to VGA, HDMI, DISPLAY PORT or AUTO. AUDIO ADJUST: To adjust the audio functions. VOLUME: To adjust the volume of speaker output. MUTE: To turn the Mute ON/OFF. AUDIO INPUT: When in HDMI input, select where the audio source comes from AU...
Page 17 - About the Stand; ) Height adjustment 2) Swivel
About the Stand The stand allows you to easily adjust the height, swivel, tilt, and portrait mode of your monitor to provide maximum ergonomic comfort. 1) Height adjustment 2) Swivel 45° 45° 110mm 3) Tilt 4) Pivot -5~15° 90° 90° 15
Page 18 - Supporting Timing Modes; Simultaneously press
Supporting Timing Modes STANDARD RESOLUTION VGA 720 x 400 @ 70Hz VGA 640 x 480 @ 60Hz MAC 640 x 480 @ 67Hz VESA 640 x 480 @ 72Hz VESA 640 x 480 @ 75Hz VESA 800 x 600 @ 56Hz VESA 800 x 600 @ 60Hz VESA 800 x 600 @ 72Hz VESA 800 x 600 @ 75Hz MAC 832 x 624 @ 75Hz VESA 1024 x 768 @ 60Hz VESA 1024 x 768 @...
Page 19 - Technical Information
Technical Information Panel 23.6” TFT (with LED backlight) Power Management On: 3 2 Watts (typical), 3 5 Watts (maximum) Standby Mode: < 0.5 Watt Off: < 0.5 Watt Displayable Resolution Full HD 1920 x 1080 max. Vertical Frequency 60Hz max. Pixel Dimension 0.2715 x 0.2715 mm Display Color 16.7M ...
Page 20 - Wall-Mount Installation Instructions; Preparing to Install the Optional Wall Mount Arm (not included)
Wall-Mount Installation Instructions Preparing to Install the Optional Wall Mount Arm (not included) This LED LCD Monitor can be attached to a wall mounting arm purchased separately. Turn the power OFF then disconnect the cables from the LED LCD Monitor before performing the procedure below. 1. Lay ...
Page 21 - Troubleshooting; No power; Power on but no screen image; Connect the LED LCD Monitor to another computer.
Troubleshooting No power Make sure A/C power cord is securely connected to the power adapter and the power supply is firmly connected to the LED LCD Monitor. Plug another electrical device into the power outlet to verify that the outlet is supplying proper voltage. Make sure all signal cables are in...
Page 22 - Cables and Accessories; Planar Support
20 Planar Support Cables and Accessories To find cables and accessories for your Planar monitor, touch screen or other Planar products visit our online store at www.PlanarOnline.com . Technical Support Visit Planar at http://www.planar.com/support for operations manuals, touchscreen drivers, warrant...