Page 5 - TABLE OF CONTENTS; General Information; Operation of the Monitor
5 TABLE OF CONTENTS FOR YOUR SAFETY For Your Safety -------------------------------------------------------------------------------------6 GENERAL NOTES 1. Introduction --------------------------------------------------------------------------------------8 1.1 General Information 1.2 Features 1.3 Ch...
Page 6 - FOR YOUR SAFETY; LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE; with the emission limits.
6 FOR YOUR SAFETY Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for...
Page 7 - PRECAUTIONS
7 PRECAUTIONS 1. Unplug the monitor from the power source when you clean the monitor. Do not use liquid cleaners or aerosol cleaners. Use a cloth to clean it. If that doesn’t do, please use LCD screen cleaners. 2. Do not use attachment not recommended as they may cause hazards. 3. Please grasp the p...
Page 11 - Power LED Indicator
11 3. Operation of the Monitor 3.1 Power On/Off Switch This is a light-touch digital-control key. It is used to turn the monitor on or off. 3.2 Power LED Indicator When the monitor is working, the power LED is green. If the monitor is in saving power mode, the power LED will be red and flashing. If ...
Page 13 - Signal source
13 3.3.6 Function Table Display contents Function AUTO ADJUSTMENT Automatically adjust to obtain the best setting BRIGHTNESS Adjust the brightness CONTRAST Adjust the contrast H-POSITION Move the screen toward left or right V-POSITION Move the screen upward or downward CLOCK Adjust the frequency of ...
Page 15 - Mode
15 3.4 Safety Mode When the video signal exceeds the frequency range of the monitor, t he monitor MCU will stop horizontal and vertical scanning in order to protect the monitor the following image will be displayed on the screen. After a few seconds, the monitor will enter turn-off mode. You must re...
Page 16 - On
16 3.6 Plug & Play This monitor meets the standard of VESA DDC. When using video card with VESA DDC1/2B, it will auto-scan video frequency, output power , function and other data to the PC when computer is on. It will go into the proper video mode and frequency. 3.7 Power Management This monitor...
Page 18 - Symptom
18 5. Simple Troubleshooting Symptom Solution No picture / no LED Check if the power cord, the monitor and the power plug are well connected. Check also if the monitor is off. No picture / Red LED flashing Check if the PC video card and signal cable are well connected and check if signal cable is pr...