Planar LC1200R - Manuals

LC1200R User’s Guide 021-0183-00 Rev A 9 of 29 2.11 Button Board The button board controls the user controls noted in Section 6.1 LCD Controller Board Controls It can be removed or mounted in another area after initial adjustments are made. 3 Environmental 3.1 Temperature and Humidity The LC1200R wi...

LC1200R User’s Guide 021-0183-00 Rev A 10 of 29 3.2 Direct Sunlight Operation This monitor will absorb approximately 45 W of solar power on the front surface of the display in a typical setup when facing the sun directly. It is the integrator’s responsibility to design a system that cools the front ...

LC1200R User’s Guide 021-0183-00 Rev A 11 of 29 4 Video Signal Requirements 4.1 Video Input Lines The video signal connector that connects to the customer’s equipment is a female 15-pin connector in a high density 9-pin D-Shell housing. Pin number assignments are defined in Table 4, and physical lay...

LC1200R User’s Guide 021-0183-00 Rev A 12 of 29 defined as a level between 0-mv and 10-mv. The white state (full white) is dependent on the VGA controller driving the LC1200R. Maximum levels may range from 550-mv to 714-mv. Nominal 680-mv input voltage shall be defined as the default for supplier se...

LC1200R User’s Guide 021-0183-00 Rev A 13 of 29 Figure 4 TTL Allowable Signal Levels

LC1200R User’s Guide 021-0183-00 Rev A 14 of 29 4.2.3 Mode Detection The polarity of incoming horizontal/vertical frequencies and synchronization pulses define the video resolution being presented. Video modes are listed in Table 5 Video Mode Definitions . Table Table Table Table 5 5 5 5 Video Mode ...

LC1200R User’s Guide 021-0183-00 Rev A 15 of 29 4.4 Timing and Frequency 4.4.1 Video, Horizontal and Vertical Sync Figure 6 illustrate video timing relationships the LC1200R operates within when the specified video mode (Table 5 Video Mode Definitions) is applied. Front Porch defines the time from e...

LC1200R User’s Guide 021-0183-00 Rev A 16 of 29 Pulse Vertical Front Porch 0.381 ms 12 lines 0.318 ms 10 lines 0.770 ms 37 lines 0.053 ms 3 lines Vertical Back Porch 1.112 ms 35 lines 1.049 ms 33 lines 0.478 ms 23 lines 0.514 ms 29 lines Vertical Active Display 12.711 ms 400 lines 15.254 ms 480 line...

LC1200R User’s Guide 021-0183-00 Rev A 17 of 29 The LC1200R is not damaged by input voltages ranging from 0-vdc to 12.4-vdc. 5.3 Power On-Off Sequences The LC1200R will automatically return to normal operation upon resumption of power after a power loss. 6 User Controls 6.1 LCD Controller Board Cont...

LC1200R User’s Guide 021-0183-00 Rev A 18 of 29 The Gain adjustment is to allow the full scale of the input video to be utilized. The direction of this adjustment will reverse when a limit is reached. For example, it will adjust from maximum to minimum, then reverse and go from minimum to maximum. T...

LC1200R User’s Guide 021-0183-00 Rev A 19 of 29 6.2.2 Max Bright Jumper The photodiode board can be removed from the system. When the photodiode board is unplugged the LC1200R will default to the minimum brightness mode. If the user would like to display to run at maximum brightness, the MAX BRIGHT,...

LC1200R User’s Guide 021-0183-00 Rev A 20 of 29 6.3 Dimming 6.3.1 Photodiode Board and Automatic Dimming Connector The photodiode board must be mounted in the user’s system so that the photodiode is exposed to the ambient light. In bright conditions, the LC1200R will adjust to maximum brightness. In...

LC1200R User’s Guide 021-0183-00 Rev A 21 of 29 The typical monitor brightness vs. ambient is as follows: Figure Figure Figure Figure 9 9 9 9 . Monitor Brightness vs. Ambient . Monitor Brightness vs. Ambient . Monitor Brightness vs. Ambient . Monitor Brightness vs. Ambient 6.3.4 Manual Brightness Mo...

LC1200R User’s Guide 021-0183-00 Rev A 22 of 29 Figure Figure Figure Figure 10 10 10 10 0 200 400 600 800 1 000 1 200 1 400 1 600 1 1 .5 2 2.5 3 3.5 4 DIM input, volts B righ tn e s s, nit s 6.3.5 Maximum Brightness Mode If constant maximum brightness is desired, a jumper may be installed at locatio...

LC1200R User’s Guide 021-0183-00 Rev A 23 of 29 Planar LC12 Vie wing Angle 0 50 100 150 200 250 300 -80 -60 -40 -20 0 20 40 60 80 Horizontal Viewing Angle (°) Co n tr as t Ra ti o 7.3 Display View Angle 110 Hor. -35 . + 55 vert. CR> 10 Planar LC12 Viewing Angle 0 50 100 150 200 250 300 350 400 -8...

LC1200R User’s Guide 021-0183-00 Rev A 24 of 29 White color is concentrated around 5600ºK color temperature. 8 Display Cosmetics The external visual inspection shall be conducted with the unaided eye at a minimum of 35 cm [14in] from the display surface. There are acceptable defects when the display...

LC1200R User’s Guide 021-0183-00 Rev A 25 of 29 Council Directive 89/336/EEC, 92/31/EEC and 93/68/EEC (Latest Amendment) on the approximation of the laws of the Member States relating to electromagnetic compatibility is based on compliance with the following harmonized standards: • Electromagnetic E...

LC1200R User’s Guide 021-0183-00 Rev A 26 of 29 Figure Figure Figure Figure 11 11 11 11 Sample of Product labeling Sample of Product labeling Sample of Product labeling Sample of Product labeling 9.6 ROHS Compliance This product will be compliant by June 30, 2006 10 Reliability 10.1 Design Workload ...

LC1200R User’s Guide 021-0183-00 Rev A 27 of 29 claim notice and only after receiving Seller’s Return Goods Authorization. Seller shall, at its sole option, repair or replace the Goods. If Goods were repaired, altered or modified by persons other than Seller, this warranty is void. Conditions result...

LC1200R User’s Guide 021-0183-00 Rev A 28 of 29 Hours: M-F, 7:00am - 4pm CET 13 Glossary of Terms Aspect Ratio: The ratio of width to height of a display surface. The standard television aspect ratio is 4:3. Back Porch: The portion of a composite display signal which lies between the trailing edges ...