Page 2 - Important Safety Information
2 1-800-732-2677 www.petsafe.net 3 Important Safety Information Explanation of Attention Words and Symbols used in this guide This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or de...
Page 4 - Table of Contents; Operating Guide
4 1-800-732-2677 www.petsafe.net 5 Thank you for choosing PetSafe ® brand. You and your pet deserve a companionship that includes memorable moments and a shared understanding together. Our products and training tools promote a lifestyle of protection, teaching, and love — essentials that influence m...
Page 5 - Other Items You May Need
www.petsafe.net 5 Components Transmitter Operating andTraining Guide Receiver Collar with Short Contact Points Test Light Tool Receiver Charger Contact Point Wrench Long Contact Points Boundary Flags - 50 Transmitter Power Adapter stay + play wi reless fence ™ opera ting and tra ining guid e Mo del ...
Page 6 - PET AREA; How the System Works; Key Definitions
6 1-800-732-2677 www.petsafe.net 7 Note: In many neighborhoods, nearby property lines may limit how large the Pet Area can be. Maximum 105 ft. range (53 average steps) PET AREA Transmitter How the System Works The PetSafe ® Stay + Play Wireless Fence ™ has been proven safe, comfortable, and effectiv...
Page 7 - Step
www.petsafe.net 7 Transmitter Power Light LO W HIG H Power Jack Boundary Switch Boundary Control Dial LOW HIGH ALARM ALARM Alarm Disable Button Operating Guide Set Up the Transmitter Important: You may need to move the Transmitter several times before determining the final location. The Transmitter ...
Page 8 - Charge the Receiver Collar; Prepare the Receiver Collar; Turning the Receiver Collar ON
www.petsafe.net 9 Charge the Receiver Collar The Receiver Collar Charger is designed to plug into a standard AC wall outlet. The Receiver Collar light will glow red when the Receiver Charger is properly seated into the Receiver Charge Jack. The light will turn green when charging is complete. A buil...
Page 9 - Receiver Collar Status Indicators; Receiver Collar Status Indicator Table
www.petsafe.net 9 Receiver Collar Status Indicators The Receiver Collar Status Indicator Light along with the Receiver Collar Alarm Tone are used to determine the battery status, and the correction type. Refer to the Receiver Collar Status Indicator Table below to understand the status lights and to...
Page 10 - To Set the Static Correction Level; Function and Response Table; Over Correction Protection
10 1-800-732-2677 www.petsafe.net 11 To Set the Static Correction Level Read all steps before attempting to set the Static Correction Level. 1. Press the Mode Button and release ( 3B ) when the Receiver Indicator Light illuminates Red ( 3C ). 2. The Receiver Indicator Light will emit a series of Red...
Page 11 - Adjust the Pet Area to Desired Size; Test Light Instructions
www.petsafe.net 11 Adjust the Pet Area to Desired Size Make sure the entire Pet Area lies within your property boundaries ( 4A ). Always start determining the Boundary Zone at the shortest distance from Transmitter. Place the Boundary Switch on “Low” if the Boundary Zone will be less than 45 feet fr...
Page 13 - Fit the Receiver Collar
www.petsafe.net 13 Fit the Receiver Collar Important: The proper fit and placement of your Receiver Collar is important for effective training. The Contact Points must have direct contact with your pet’s skin on the underside of his neck. Please read and follow the instructions in this manual. Prope...
Page 14 - To Re-Thread the Collar
14 1-800-732-2677 www.petsafe.net 15 5. Check the tightness of the Receiver Collar by inserting one finger between the end of a Contact Point and your pet’s neck. The fit should be snug but not constricting ( 6B ). 6. Allow your pet to wear the collar for several minutes then recheck the fit. Check ...
Page 16 - Day 1 - Boundary Awareness; Tone Only Training Mode; Phase
16 1-800-732-2677 www.petsafe.net 17 Day 1 - Boundary Awareness Tone Only Training Mode Perform three sessions on day 1, each training session lasting 10-15 minutes. Goal: To have your pet learn that the Boundary Flags and warning beep from the Receiver Collar define the new Pet Area. Setup: • Progr...
Page 17 - Introduction to Static Correction; Days 5 thru 8 - Distraction Phase
www.petsafe.net 17 Days 2 thru 4 - Continue Boundary Awareness Introduction to Static Correction Perform three sessions per day, each lasting 10-15 minutes. Goal: To train your pet to stay in the Pet Area and respect the boundary. Setup: • Program the Static Correction Level on the Receiver Collar t...
Page 19 - Days 15 thru 30 - Pet Monitoring; You have now
www.petsafe.net 19 Days 15 thru 30 - Pet Monitoring Your pet is ready to run! Check in on your pet at regular intervals.Note: After you are satisfied your pet’s training is complete, remove every other Boundary Flag every 4 days until all flags are removed. Save Boundary Flags for future use. Taking...
Page 20 - Accessories
20 1-800-732-2677 www.petsafe.net 21 Wireless-To-Go Your PetSafe ® Stay + Play Wireless Fence ™ is completely portable. Follow the set-up procedures (Steps 1 through 4) wherever you wish to have containment of your pet. Reestablish the Pet Area and mark it with Boundary Flags so your pet knows his B...
Page 21 - Frequently Asked Questions
www.petsafe.net 21 Frequently Asked Questions Is the Receiver Collar waterproof? • Yes. Will the PetSafe ® Stay + Play Wireless Fence ™ cover a larger circle than 210 feet across? • You can use another Wireless Transmitter with overlapping boundaries of at least 5-10 feet to increase the size of the...
Page 23 - Troubleshooting
www.petsafe.net 23 Troubleshooting The Receiver Collar is not beeping when setting up the Boundary Zone. • Make sure Receiver Collar is turned on and Battery Status Lights are flashing every 4-5 seconds • Charge Receiver Collar • The beep may be difficult to hear in a noisy environment. • Use Test L...
Page 27 - Compliance; Australia; Customer Care International
www.petsafe.net 27 Compliance FCC/Canada This Class B digital apparatus complies with Canadian ICES-003. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection a...