Pelco C2410M-G - Manuals - manualsarea.com

Page 3 - CONTENTS; Section

Pelco Manual C2410M-G (1/04) [ 3 ] CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS ..................................................................................... 4 DESCRIPTION ................................................................................................................

Page 4 - IMPORTANT SAFEGUARDS AND WARNINGS; the bolt holes between the enclosure and mounting surface.; DESCRIPTION; The 150 Series Camclosure; INSTALLATION; Install Back Box; Mounting Directly to Wall or Ceiling; Attach the back box to the wall or ceiling.

[ 4 ] Pelco Manual C2410M-G (1/04) IMPORTANT SAFEGUARDS AND WARNINGS 1. Installation and servicing should be done only by qualified service personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6 or 6P enclosure, it is designed for indoo...

Page 5 - Mounting to 4S Deep Electrical Box; Using the adapter plate as a template, cut; Install Camera; Some indoor installations do not require a; C A U T I O N

Pelco Manual C2410M-G (1/04) [ 5 ] 8.32 X .750 SCREW(SUPPLIED) 8.32 X .375 SCREW(SUPPLIED) WALL ORCEILING ADAPTER PLATE BACK BOX 4S DEEPELECTRICALBOX 01063 CEILING TILE BACK BOX ADAPTER PLATE 8-32 X 1.25MOUNTINGHARDWARE(SUPPLIED) 01062 Mounting to 4S Deep Electrical Box 1. Attach adapter plate to th...

Page 6 - Wall Mounting; - The camera bracket; Ceiling Mounting; Turn on power to the camera and monitor.

[ 6 ] Pelco Manual C2410M-G (1/04) 24 VAC JUMPER 12 VDC JUMPER VIDEOCONNECTOR HEATERCONNECTOR 01065 VIDEOCONNECTOR HEATERCONNECTOR 01068 CAMERA BRACKETTAB ALWAYS POINTSOUT OF THEENCLOSURE 01071 CAMERA BRACKETTAB ALWAYS POINTSOUT OF THEENCLOSURE TOP OFCAMERA 01086 Wall Mounting - The camera bracket t...

Page 7 - Install Dome and Trim Ring

Pelco Manual C2410M-G (1/04) [ 7 ] ADJUSTMENTS (COLOR CAMERA ONLY) If you have a color camera, it is set up at the factory and normally requires no adjustments. Sometimes,however, adjustments may be necessary. 1. Remove the dome and trim ring using the supplied 1/8-inch hollow screwdriver bit. 2. Ad...

Page 8 - To remove the heater board:; Auto Iris Level Adjustment

[ 8 ] Pelco Manual C2410M-G (1/04) Focus Adjustment for Fixed Focal Length Lenswith Auto Iris To adjust the focus, it may be necessary to remove the heater board in order to loosen the locking screwon the bottom of the lens. To remove the heater board: 1. Disconnect the four-pin heater wiring.2. Wai...

Page 10 - SPECIFICATIONS; General; Switch Settings for Varifocal Lens; To enable automatic exposure; CAUTION; Electrical

[ 10 ] Pelco Manual C2410M-G (1/04) (Design and product specifications subject to change without notice.) SPECIFICATIONS General OperatingTemperature: -50 ° to 122 ° F (-46 ° to 50 ° C) De-ices to 25 ° F (-4 ° C) Pan/TiltAdjustment: Manual; 360 ° pan; 180 ° tilt Construction: Aluminum with steel cam...

Page 11 - Regulatory Notices; Reorient or relocate the receiving antenna.

Pelco Manual C2410M-G (1/04) [ 11 ] REVISION HISTORY Manual # Date Comments C2410M 11/99 Original version. C2410M 1/00 Revised installation instructions. Added FCC notices. C2410M-A 1/00 Added varifocal lens. Changed format. C2410M-B 7/00 Added information on dome liner. C2410M-C 1/01 Added heater e...

Page 12 - WARRANTY AND RETURN INFORMATION

[ 12 ] Pelco Manual C2410M-G (1/04) WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one yearafter the date of shipment. Exceptions to this warranty are as noted below: • Five years on P...