OmniMount 10081 - Manuals - manualsarea.com

Page 2 - SYMBOL KEY

P2 SYMBOL KEY Retirez Retire Remove ENESFR Ajustez Ajuste Adjust ENESFR Gestion des câbles Sistema de organización de cables Cable Management ENESFR Serrer avec les doigts Ajuste manual Hand tighten ENESFR Tighten Fastener EN Ajuste el sujetador ES Serrez l'attache FR Loosen Fastener EN Afloje el su...

Page 3 - CONTENTS; TOOLS NEEDED; Contents

P3 CONTENTS Tools Needed EN Herramientas necesarias ES Outils requis FR Not included EN No se incluye ES Non inclus FR TOOLS NEEDED P-B P-D P-C P-A 4 2 2 3 Flange 1 4 Center Cover 2 3 J-box Cover 4 2 Wall Box 1 1 N/A Contents Washer .344" ID x .69" OD x .065" THK 6 P-F 6 Acorn Hex Nut M8...

Page 4 - or serious injury can occur if proper care is not taken.

P4 OPTION A / ROUGH IN Please contact a qualified contractor for all custom installation. Death or serious injury can occur if proper care is not taken. Take caution of electrical and plumbing that may be within the wall framing. Serious damage to persons or property can occur from improper construc...

Page 5 - Create support for cut stud; . Contact a qualified contractor; OPTIONS; Cut; OPTIONS

P5 Couper Corte Cut ENESFR Create support for cut stud . Contact a qualified contractor to review building codes for your area. OPTIONS B Couper Corte Cut ENESFR A OPTIONS 31. 75” 16.5” 19”

Page 6 - Good; Level; STUD; Install supports using wood screws

P6 OPTIONS Good No Good OPTIONS Level EN Nivel ES Niveau FR STUD STUD SUPPORT Create support for cut stud . Contact a qualified contractor to review building codes for your area. Install supports using wood screws (not included). A A B STUD 16” B STUD STUD STUD STUD STUD

Page 7 - Wood Pilot; Pilot Hole Size

P7 STEP 1 Wood Pilot Pilot Hole Size Pilot Drill Depth 7/32” inch 2 inch 4 mm 50 mm STUD STEP 2 Installation murale sur poteau de cloison en bois FR Instalación en pared con paneles de madera ES Wood Stud Wall Installation EN Percez le trou de guidage Realice el agujero piloto Drill pilot hole Utili...

Page 8 - Tighten Fastener; Install Shadow Box using lag screws; DO NOT OVERTIGHTEN; Important; Up

P8 X 8 Tighten Fastener EN Ajuste el sujetador ES Serrez l'attache FR P-C P-A P-C P-A Install Shadow Box using lag screws (Part P-A) and hex drive (Part P-C). DO NOT OVERTIGHTEN Important EN Importante ES Important FR Haut Arriba Up ENESFR STEP 3

Page 11 - Cable Management; Remove

P11 STEP 8 X 6 P-F P-E Tighten Fastener EN Ajuste el sujetador ES Serrez l'attache FR OPTIONS Gestion des câbles Sistema de organización de cables Cable Management ENESFR Retirez Retire Remove ENESFR

Page 12 - THANK YOU FOR PURCHASING AN OMNIMOUNT PRODUCT

P12 This warranty applies to US Residents who purchase from an authorized OmniMount Dealer. OmniMount products are covered against defects in materials and workmanship for 5 years. OmniMount will repair or replace the defective component or product, at its sole discretion. Failure to follow produc...