Nilfisk ALTO SPS-28 E - Manuals

Page 2 - Table of Contents; How to Prepare the Machine for Operation; Parts and Service Manual - Section II

Page 2 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Table of Contents Operator Safety Instructions ................................................................................... 3Operator Safety Instructions Battery Powered Machine .......................................... 4 ...

Page 3 - OPERATOR SAFETY INSTRUCTIONS

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 3 OPERATOR SAFETY INSTRUCTIONS DANGER means: Severe bodily injury or death can occur to you or other personnel if the DAN- GER statements found on your machine or in your Owner's Manual are ignored or are not adhered to. Read and ob...

Page 4 - WARNING: Leave the machine only on a level surface; Operator Safety Instructions for Battery Powered Machine

Page 4 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual CAUTION: Connect or disconnect the battery plug onlywhen the charger supply cord is disconnectedor arcing and burning may result. CAUTION: Do not expose to rain. Replace defective cordsimmediately. If the charger is dropped or oth...

Page 5 - INTRODUCTION; SPECIFICATIONS

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 5 INTRODUCTION The Model SPS-28 will effectively and efficiently sweep your floors at minimum cost, provided you operate thismachine with reasonable care and maintain it in accordance with the intructions contained in this operator'...

Page 6 - How to Prepare The Machine for Operation

Page 6 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual How to Prepare The Machine for Operation Model 28G (Gasoline Powered) NOTE: Do not attempt to operate the CLARKE Model SPS-28 before reading the instructions in this manual. WARNING: To prevent injury , always wear protec- tive cl...

Page 7 - HOW TO CHARGE THE BATTERIES

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 7 How to Prepare The Machine for Operation 1. Before starting the SPS-28B lift the battery box cover andmake sure the battery cables are connected. 2. Place all controls in "NEUTRAL". 3. Turn OFF/ON switch to "ON" po...

Page 8 - HOW TO OPERATE THE MACHINE; WARNING: Do not check the engine oil level when

Page 8 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual HOW TO OPERATE THE MACHINE NOTE: Do not attempt to operate the CLARKE Model SPS-28 before reading the instructions in this manual. WARNING: To prevent injury , always wear protec- tive clothing. Do not wear loose cloth-ing. WARNIN...

Page 11 - Space Sweeper; Section II; Parts and Service Manual

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 11 SPS-28 Space Sweeper (INCLUDES 28G & 28B) Section II Parts and Service Manual (70100B)

Page 12 - SERVICE AND MAINTENANCE

Page 12 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual SERVICE AND MAINTENANCE WARNING: Maintenance and repairs must be done by authorized personnel only. KeepAdjustments according to specifications. WARNING: To prevent injury always stop the en- gine or motor before doing any mainte...

Page 14 - Installation of New Main Brush; SHOP EVALUATION OF CHARGERS; WARNING: Always wear eye and face shield,

Page 14 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Installation of New Main Brush (cont) Remove the three screws and washers and the bristlestrip retained by them. Install the new strip and assemblethe retaining screws and washers. Be sure to install the"V" of each strip ...

Page 15 - Capacitor Test

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 15 Capacitor Test If a commercial capacitor checker is not available, thefollowing test may be made: 1. Briefly short the capacitor terminals together with a screwdriver. 2. Disconnect a wire from either capacitor terminal. 3. Adjus...

Page 16 - CLARKE TECHNOLOGY Model SPS-28

Page 16 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual CLARKE TECHNOLOGY Model SPS-28 Main Frame, Brush Assembly and Drive System Drawing 1/99 87 86 95 28 42 77 75 76 74 4 5 6 24 25 26 71 96 70 3 96 4 78 22 36 67 37 22 88 49 32 33 62 69 49 60 25 57 56 55 52 54 53 90 34 52 51 82 65 49...

Page 20 - CLARKE

Page 20 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual CLARKE TECHNOLOGY Model SPS-28 Hopper and Optional Sidebroom Assembly Drawing 1/99 49 34 BOTTOM TOP 27 28 51 52 50 53 54 55 52 OPTIONALSIDE BROOMASSEMBLY 62 43 43 44 45 46 41 48 13 40 39 38 37 5758 61 32 33 33 32 35 36 29 30 31 2...

Page 26 - NOTE

Page 26 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual NOTE S

Page 27 - ALTO; European Locations

CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual Page 27 ALTO ® PRODUCT SUPPORT BRANCHES PRODUCTION FACILITIES ALTO Danmark A/S, Aalborg Blytaekkervej 2DK-9000 Aalborg+45 72 18 21 00 ALTO Danmark A/S, Hadsund IndustrikvarteretDK-9560 Hadsund+45 72 18 21 00 SALES SUBSIDIARIES ALTO Canad...

Page 28 - Always use genuine Clarke Parts for repair.

CLARKE TECHNOLOGY LIMITED U.S. WARRANTY This Clarke Industrial/Commercial Product is warranted to be free from defects in materials and workmanship under normal use and service for a period of one year from the date of purchase, when operated and maintained in accordancewith Clarke's Maintenance and...