Nilfisk ALTO S12 - Manuals - manualsarea.com

Page 2 - Table of Contents

Page -2- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Table of Contents Operator Safety Instructions ................................................................................... 3Grounding Instructions ...............................................................................

Page 3 - OPERATOR SAFETY INSTRUCTIONS; WARNING

Page -3- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual OPERATOR SAFETY INSTRUCTIONS WARNING AVERTISSEMENT ADVERTENCIA For the safe operation of this machine, read and understand all dangers, warnings andcautions. Look for these symbols: DANGER : If you do not follow the instructions in...

Page 4 - SAVE THESE INSTRUCTIONS

Page -4- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual SAVE THESE INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury: 16. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt. 17. Do not u...

Page 5 - FIGURE A

Page -5- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual GROUNDING INSTRUCTIONS Preparation: The following are instructions for connection to the power supply and the electrical ground. This machine must be connected to the electrical ground to protect the operator from electrical shock....

Page 6 - CONSIGNES DE SÉCURITÈ DE L'UTILISATEUR; DANGER

Page -6- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CONSIGNES DE SÉCURITÈ DE L'UTILISATEUR AVERTISSEMENT Pour utiliser cet appareil en toute sécurité, il faut lire et coprendre tous les consignes de danger,d'avertissement et d'attention. Soyez attentif aux symboles que voici. DANGER...

Page 7 - CONSERVEZ CES INSTRUCTIONS

Page -7- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual 16. Ne remassez pas de objets qui brûient ou fument comme les cigarettes, les allumettes ou les cendres chaudes. 17. Les poulies de la courroie peuvent devenir chaudes pendant l'utilisation normale. Pour prévenir des brûlures, évit...

Page 9 - HOW TO PREPARE THE MACHINE FOR OPERATION; Figure 1; Store

Page -9- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual HOW TO PREPARE THE MACHINE FOR OPERATION Assemble the Handle Attach upper (A) and lower (B) handle to handlesocket (C) by aligning holes and securing with 2 partscrews (D). See figure 1. Install the Bag Assembly Position the bag co...

Page 10 - Figure 4

Page -10- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual MAINTENANCE This section describes the procedures that must bedone by the operator. WARNING: To prevent injury, always turn off the switch and remove the electrical plug from the electrical outlet before changing the brush, belt, ...

Page 11 - Figure 6

Page -11- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual MAINTENANCE (CONT.) 9. Place the rubber end cap covers over both end caps (flat side against end cap). Align holes and secure. Then, slant the brush roll forward so the end caps are in line with the slots in the cleaner base. Push...

Page 12 - Figure 9

Page -12- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Steel Core Brush WARNING: Turn off the switch and disconnect unit from electrical supply before replacing brush strips. 1. New brush strips inserts are supplied in sets. To replace, first disconnect the machine from the electrical...

Page 13 - Symphony Upright Vacuum

Page -13- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Symphony Upright Vacuum Wiring Diagram 11/00 CLARKE TECHNOLOGY TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION Motor does not run. 1) Not firmly plugged in. 1) Check attachment plug. 2) Bad On-Off switch. 2) Replace switch....

Page 14 - CLARKE TECHNOLOGY

Page -14- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CLARKE TECHNOLOGY Symphony Upright Vacuum Collector Cup Assembly Drawing 7/01 108

Page 15 - Qty

Page -15- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Ref. Part No. Description Qty 2 80065A Screw (M4 *10) 1 26 56489A Screw (M4 *15) 23 31 E-clip (E6) 5 35 56485A Screw (M4 * 8) 3 70 30138A Handle Grip 1 71 51240A Handle Assembly, Upper 1 72 30143A Bag Hook 1 73 30144A Bag Retainer...

Page 20 - NOTES

Page -20- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual NOTES

Page 21 - ALTO; European Locations

Page -21- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual ALTO ® PRODUCT SUPPORT BRANCHES PRODUCTION FACILITIES ALTO Danmark A/S, Aalborg Blytaekkervej 2DK-9000 Aalborg+45 72 18 21 00 ALTO Danmark A/S, Hadsund IndustrikvarteretDK-9560 Hadsund+45 72 18 21 00 SALES SUBSIDIARIES ALTO Canada...