Nilfisk ALTO MP2D - Manuals

Page 2 - SAFETY RELATED SYMBOLS; C A U T I O N; Protective Ground Terminal; WARNING; Protective Ground

SAFETY RELATED SYMBOLS C A U T I O N R I S K O F E L E C T R I C S H O C K D O N O T O P E N This symbol, wherever used, alerts you to the pre-sence of un-insulated and dangerous voltages with-in the product enclosure. These are voltages thatmay be sufficient to constitute the risk of electricshock ...

Page 3 - PREFACE

2 PREFACE Thank you for choosing MP2D Two Channels Microphone / Instrument Preamplifier with Stereo Bus and thanks LTO for choosing one of the results of LTO AUDIO TEAM job and research. For our LTO AUDIO TEAM, music and sound are more than a job ... is first of all passion and let us say our obsess...

Page 4 - TABLE OF CONTENTS

TABLE OF CONTENTS 1. INTRODUC ION T ..................................................................................................................................................4 2. FEATURES............................................................................................................

Page 5 - Inserting; Dynamics Processors; CONTROL ELEMENTS; of an acoustic or electric instrument pickup to be fully realized.; Input Gain Control; phantom Power for condenser microphone.; Phantom Power Switch

1. INTRODUCTION Congratulation! Now you are the owner of the MP2D Two Channel Microphone / Instrument Preamplifier withStereo Bus, which is provided with 129dB of signal to noise ratio and 0.007% of THD. Each channel provides an1/4 inch instrument socket , individual phantom power, phase reverse and...

Page 6 - This LED lights up when the power is on.; . 2 T h e R e a r P a n e l

5 High Pass Filter Switch The unit provides an 80Hz high pass filter for each channel. You will activate the filter by pressing this switch.This filter is useful for eliminating extraneous low-end information from the signal being amplified. Frequenciesfrom eighty hertz and below are cut from the in...

Page 8 - - XLR Connector Wiring For Phantom Power; INSTALLATION AND CONNECTION; Audio Connection

7 - XLR Connector Wiring For Phantom Power PIN1 GNDPIN 2 +48vPIN 3 +48v 4. INSTALLATION AND CONNECTION 4.1 Mains Connection 4.2 Audio Connection The MP2D presents with balanced XLR & 1/4" TRS and combo connectors, and it can be interfaced byseveral ways to support a variety of applications w...

Page 10 - TECHNICAL SPECIFICATION

6. TECHNICAL SPECIFICATION 9 Sampling Rates 44.1k, 48k, 88.2k, 96k, 176.4k, 192k Output 24-bit Digital INPUT SYSTEM SPECIFICATIONS Connectors Type Impedance Max input level CMRR XLR and 1/4" TRS (Pin 2 and Tip hot) Electronically balanced/unbalanced, RF filtered Balanced >50Kohm, Unbalanced&g...

Page 12 - manual without written permission is forbidden. Copyright; SE KAKU TECHNICAL GROUP LIMITED

N F 0 2 2 0 5 - 1 . 1 No. 1, Lane 17, Sec. 2, Han Shi West Road, Taichung 40151 Taiwan http://www.altoproaudio.com Tel: 886-4-22313737 email: [email protected] Fax: 886-4-22346757 c All rights reserved to ALTO. All features and content might be changed without prior notice. Any photocopy, transl...