Multi-Tech Systems PS9600 - Manuals

Page 3 - Federal Communications Commission Statement

CommPlete Communications Server iii Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference...

Page 5 - Table of Contents

CommPlete Communications Server v Table of Contents 1 Introduction .................................................................... 1 Introduction ........................................................................................................................................................

Page 7 - Introduction

Page 8 - Introduction; Features

PS9600 Power Supply User Guide 2 CommPlete Communications Server Introduction This manual describes the field installation of a Multi-Tech PS9600 power supply into a CommPleteCommunications Server CC9600 chassis. Installation and troubleshooting of the PS9600 should beperformed only by qualified ser...

Page 9 - Technical Specifications; Manual Organization; Chapter 2 Installation

1 Introduction CommPlete Communications Server 3 Technical Specifications Input voltage 100 VAC to 240 VAC RMS Input frequency 50/60 Hz Input current 8 A @ 115 V at full load4 A @ 230 V at full load Output voltage atmaximum current 5 VDC @ 65 A21 VDC @ 0.5 A 5 V regulation ± 0.1% at full load 5 V OV...

Page 11 - Installation

Page 12 - Installation Procedure

PS9600 Power Supply User Guide 6 CommPlete Communications Server Introduction This chapter describes how to install the PS9600 power supply into a CommPlete Communication ServerCC9600 chassis. This equipment should be installed only by a qualified service person. Pre-Installation Notes • All install...

Page 13 - Operation

Page 15 - Solving Problems

CommPlete Communications Server 9 4 Solving Problems

Page 16 - LED Indicators; Adjustment of the PS9600 Power Supply

PS9600 Power Supply User Guide 10 CommPlete Communications Server Introduction This chapter provides information needed to identify and fix problems with the PS9600 power supplymodule. Problems can be observed on the CommPlete system’s front panel LEDs, the control PC’s screen,or via audio alarm or ...

Page 17 - Important Safety Considerations; Fuse Replacement

4 Solving Problems CommPlete Communications Server 11 Procedure 1. Turn off the power supply that is not being adjusted. 2. Place your voltmeter’s probes on the test points. 3. Two trimpots, one for each power supply, are located on the back of the chassis between the powersupply fans. Adjust the 5 ...

Page 18 - Insertion and Removal of a Power Supply

PS9600 Power Supply User Guide 12 CommPlete Communications Server Insertion and Removal of a Power Supply Qualified service personnel may insert or remove a power supply without turning off the system. Werecommend that you insert the power supply slowly. If the power supply is not replaced, a cover ...

Page 19 - Index

CommPlete Communications Server 13 Index —A— adjusting the output, 11 —B— BBS, Multi-Tech, 16 —C— CC9600 chassis, 6CompuServe, 17 —D— description, 2dimensions of PS9600, 3 —F— fax-back service, 18features, 2fuse, 3, 10 —I— installation, 6Internet, 2, 18 —L— LED, 10 —M— manual organization, 3Multi-Te...