Makita NHP1310 - Manuals - manualsarea.com

Page 2 - SPECIFICATIONS; GENERAL SAFETY RULES; Read and understand all instructions.; Failure to follow all; SAVE THESE INSTRUCTIONS

2 SPECIFICATIONS • Manufacturer reserves the right to change specifications without notice. • Specifications may differ from country to country. GENERAL SAFETY RULES USA002-2 (For All Tools) WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in...

Page 4 - SPECIFIC SAFETY RULES

4 22. Use only accessories that are recom- mended by the manufacturer for yourmodel. Accessories that may be suitable for one tool, may become hazardous when usedon another tool. SERVICE 23. Tool service must be performed only by qualified repair personnel. Service or main- tenance performed by unqu...

Page 7 - ASSEMBLY

7 Speed change Two speed ranges can be preselected with the speedchange lever. To change the speed, press the speed change lever andslide it to the “LO” position for low speed or the “HI” positionfor high speed. If the speed change lever does not slide eas-ily, turn the chuck slightly in either dire...

Page 8 - Installing or removing drill bit; OPERATION; Hammer drilling operation

8 Installing side grip (auxiliary handle) Screw the side grip on the tool securely. Installing or removing drill bit To install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Place the chuck key in each ofthe three holes and tighten clockwise. Be sure to tighten allth...

Page 9 - Drilling operation

9 When drilling in concrete, granite, tile, etc., turn the actionmode changing knob to the position of symbol to use “rotation with hammering” action. Be sure to use a tungsten-carbide tipped bit.Position the bit at the desired location for the hole, then pullthe switch trigger. Do not force the too...

Page 10 - MAINTENANCE

10 Drilling in wood When drilling in wood, the best results are obtained withwood drills equipped with a guide screw. The guide screwmakes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, makean indentation with a center-...

Page 11 - Memo

Page 14 - MAIL THIS PORTION; Your answers to the following questions are appreciated.; Please return this portion by facsimile or mail.

14 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

Page 15 - FACTORY SERVICE CENTERS; RETAIN THIS PORTION FOR YOUR RECORDS

15 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 CALIFORNIA 41850 Christy St. Fremont, CA 94538-5107 (510) 657-9881 14930 Northam St. La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacrame...

Page 16 - WARNING; MAKITA LIMITED ONE YEAR WARRANTY; Warranty Policy; Makita Corporation

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...

Makita NHP1310 - Manuals

Manuals:

Manual Makita NHP1310

Summary

Makita Manuals