Makita LS1030N - Manuals

7 INSTALLATION Bench mounting When the tool is shipped, the handle is locked in the loweredposition by the stopper pin. Release the stopper pin by lower-ing the handle slightly and pulling the stopper pin. This tool should be bolted with two bolts to a level and stablesurface using the bolt holes pr...

10 WARNING: • NEVER use tool without a fully operative switch trigger.Any tool with an inoperative switch is HIGHLYDANGEROUS and must be repaired before furtherusage. • For your safety, this tool is equipped with a lock-offbutton which prevents the tool from unintended starting.NEVER use the tool if...

13 Vertical vise The vertical vise can be installed on the guide fence or theholder assembly (optional accessory). Insert the vise rod intothe hole in the guide fence or the holder assembly andtighten the screw to secure the vise rod. Position the vise arm according to the thickness and shapeof the ...

14 Holders and holder assembly (optional accessories) The holders and the holder assembly can be installed oneither side as a convenient means of supporting workpieceshorizontally. Install them as shown in the figure. Then tightenthe screws firmly to secure the holders and the holderassembly. When c...

15 1. Press cutting Secure the workpiece with the vise. Switch on the toolwithout the blade making any contact and wait until theblade attains full speed before lowering. Then gentlylower the handle to the fully lowered position to cut theworkpiece. When the cut is completed, switch off the tooland ...

16 Use the crown molding stoppers (optional accessories)when cutting the corners((1) - (4) in Fig.A). Install themon the base as shown in the figures. Position crown molding with its WALL CONTACT EDGEagainst the guide fence and its CEILING CONTACTEDGE against the crown molding stoppers as shown inth...

17 CAUTION: • Use straight wood of even thickness as the wood facing. • Use screws to attach the wood facing to the guide fence.The screws should be installed so that the screw headsare below the surface of the wood facing. • When the wood facing is attached, do not turn the turnbase with the handle...

18 Carrying tool Make sure that the tool is unplugged. Secure the turn base atright miter angle fully by means of the grip. Lower the handlefully and lock it in the lowered position by pushing in the stop-per pin. Carry the tool by carrying grip as shown in the figure. If youremove the holders, dust...

20 ACCESSORIES CAUTION: • These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other accessories or attachments mightpresent a risk of injury to persons. Only use accessoryor attachment for its stated purpose. If you need any assistanc...

22 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

23 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 CALIFORNIA 41850 Christy St. Fremont, CA 94538-5107 (510) 657-9881 14930 Northam St. La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacrame...

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...