Makita HP2033 - Manuals - manualsarea.com

Page 2 - SPECIFICATIONS; GENERAL SAFETY RULES; Read and understand all instructions.; Failure to follow all; SAVE THESE INSTRUCTIONS

2 SPECIFICATIONS • Manufacturer reserves the right to change specifications without notice. • Specifications may differ from country to country. GENERAL SAFETY RULES USA002-2 (For All Tools) WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in...

Page 4 - SPECIFIC SAFETY RULES

4 21. Check for misalignment or binding of moving parts, breakage of parts, and anyother condition that may affect the toolsoperation. If damaged, have the tool ser-viced before using. Many accidents are caused by poorly maintained tools. 22. Use only accessories that are recom- mended by the manufa...

Page 8 - ASSEMBLY; Installing or removing drill bit

8 ASSEMBLY CAUTION: • Always be sure that the tool is switched off andunplugged before carrying out any work on the tool. Installing side grip (auxiliary handle) Always use the side grip to ensure operating safety. Installthe side grip so that the teeth on the grip fit in between theprotrusions on t...

Page 9 - Depth gauge; OPERATION; Hammer drilling operation

9 Depth gauge The depth gauge is convenient for drilling holes of uniformdepth. Loosen the side grip and insert the depth gauge intothe hole in the side grip. Adjust the depth gauge to thedesired depth and tighten the side grip. NOTE: • The depth gauge cannot be used at the position wherethe depth g...

Page 10 - Drilling operation

10 Blow-out bulb (optional accessory) After drilling the hole, use the blow-out bulb to clean the dustout of the hole. Drilling operation CAUTION: • Pressing excessively on the tool will not speed up thedrilling. In fact, this excessive pressure will only serve todamage the tip of your bit, decrease...

Page 11 - MAINTENANCE; Cleaning vent holes; ACCESSORIES

11 MAINTENANCE CAUTION: • Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance. Cleaning vent holes The tool and its air vents have to be kept clean. Regularlyclean the tool’s air vents or whenever the vents start tobecome obstructed. To mai...

Page 12 - Memo

Page 14 - MAIL THIS PORTION; Your answers to the following questions are appreciated.; Please return this portion by facsimile or mail.

14 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

Page 15 - FACTORY SERVICE CENTERS; RETAIN THIS PORTION FOR YOUR RECORDS

15 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 CALIFORNIA 41850 Christy St. Fremont, CA 94538-5107 (510) 657-9881 14930 Northam St. La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacrame...

Page 16 - WARNING; MAKITA LIMITED ONE YEAR WARRANTY; Warranty Policy; MAKITA MANUFACTURING EUROPE LTD

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...

Makita HP2033 - Manuals

Manuals:

Manual Makita HP2033

Summary

Makita Manuals