Makita HP2010N - Manuals - manualsarea.com

Page 2 - SPECIFICATIONS; GENERAL SAFETY RULES; Read and understand all instructions.; Failure to follow all; SAVE THESE INSTRUCTIONS

2 SPECIFICATIONS • Manufacturer reserves the right to change specifications without notice. • Specifications may differ from country to country. GENERAL SAFETY RULES USA002-2 (For All Tools) WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in...

Page 4 - SPECIFIC SAFETY RULES

4 21. Check for misalignment or binding of moving parts, breakage of parts, and anyother condition that may affect the toolsoperation. If damaged, have the tool ser-viced before using. Many accidents are caused by poorly maintained tools. 22. Use only accessories that are recom- mended by the manufa...

Page 7 - ASSEMBLY

7 Speed change Two speed ranges can be preselected with the speedchange lever. To change the speed, press the speed change lever andslide it to the “L” position for low speed or the “H” position forhigh speed. If the speed change lever does not slide easily,turn the chuck slightly in either directio...

Page 8 - OPERATION; Hammer drilling operation

8 Installing or removing drill bit To install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Place the chuck key in each ofthe three holes and tighten clockwise. Be sure to tighten allthree chuck holes evenly.To remove the bit, turn the chuck key counterclockwise in j...

Page 9 - Drilling operation

9 Blow-out bulb (optional accessory) After drilling the hole, use the blow-out bulb to clean the dustout of the hole. Drilling operation CAUTION: • Pressing excessively on the tool will not speed up thedrilling. In fact, this excessive pressure will only serve todamage the tip of your bit, decrease ...

Page 11 - Memo

Page 14 - MAIL THIS PORTION; Your answers to the following questions are appreciated.; Please return this portion by facsimile or mail.

14 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

Page 15 - FACTORY SERVICE CENTERS; RETAIN THIS PORTION FOR YOUR RECORDS

15 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 CALIFORNIA 41850 Christy St. Fremont, CA 94538-5107 (510) 657-9881 14930 Northam St. La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacrame...

Page 16 - WARNING; MAKITA LIMITED ONE YEAR WARRANTY; Warranty Policy; Makita Corporation

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...

Makita HP2010N - Manuals

Manuals:

Manual Makita HP2010N

Summary

Makita Manuals