Makita EM4350LH - Manuals

[4] DISASSEMBLY/ASSEMBLY [4]-7. Ignition system (cont.) R epair P 1 2 / 2 2 (1) Before removing Ignition coil, separate Cylinder cover from Engine, and pull out Primary wire from Ignition coil in advance. ( Fig. 47 ) (2) Remove two M4x20 Hex socket head bolts and Ignition coil from Engine. ( Fig. 47...

[4] DISASSEMBLY/ASSEMBLY [4]-9. Recoil starter R epair P 1 3 / 2 2 (1) Remove Starter cover assembly by loosening four M5x20 Hex socket head bolts. ( Fig. 52 ) (2) Pull Starter rope out of Starter cover assembly approximately one winding long. Then hook Starter rope on the U-shaped notch of Reel, an...

[4] DISASSEMBLY/ASSEMBLY [4]-10. Carburetor section R epair P 1 4 / 2 2 (1) Press down the tab of Cleaner plate assembly gently and separate Air cleaner cover from Cleaner plate assembly by loosening M5x20 Hex socket button head screw. ( Fig. 1 of [4]-2. ) (2) Remove Air cleaner element. ( Fig. 58 )...

[4] DISASSEMBLY/ASSEMBLY [4]-13. Engine block (cont.) R epair P 18 / 2 2 ASSEMBLING (1) Connect Piston with Crank shaft complete by inserting Piston pin into place; there is no front/back to Piston. Note: Be sure to apply a little amount of Makita grease N No.2 to Needle roller bearing. (2) Secure P...

[4] DISASSEMBLY/ASSEMBLY [4]-15. Tightening torque specifications R epair P 2 2 / 2 2 Application (for fastening A and B) A B Fastener Tightening torque (N.m) Crank case Retainer plate M5x18 Hex socket head bolt 6.0 Cylinder block Crank case M6x25 Hex socket head bolt (8 pcs.) 11.0 Crank case Oil ca...