Makita BTW120 - Manuals

9 5. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch intoits “trickle charge (maintenance charge)” mode whichwill last approximately 24 hours. 6. After charging, unplug the charger from the power source. NOTE: • The battery charger is f...

11 Refresh charging Refreshing adapter (optional accessory) can refresh an inac-tive battery cartridge. Refresh charging should be done once a week. When you charge a new battery cartridge or a battery car-tridge that has not been used for a long time, it may notaccept a full charge. In this case, r...

12 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and thebattery cartridge is removed before carrying out anywork on the tool. Selecting correct socket Always use the correct size socket for bolts and nuts. Anincorrect size socket will result in inaccurate and inconsistentfastening...

13 • If the tool is operated continuously until the batterycartridge has discharged, allow the tool to rest for 15minutes before proceeding with a fresh battery. The fastening torque is affected by a wide variety of factorsincluding the following. After fastening, always check thetorque with a torqu...

14 Replacing carbon brushes Remove and check the carbon brushes regularly. Replacewhen they wear down to the limit mark. Keep the carbonbrushes clean and free to slip in the holders. Both carbonbrushes should be replaced at the same time. Use only iden-tical carbon brushes. Use a screwdriver to remo...

18 1. This product was purchased from: Home Center Hardware/Lumber Store Tool Distributor Industrial Supply Construction Supply Other ( ) 3. How did you learn about this product: Magazine From Dealer Newspaper Store Display Catalog Radio Exhibition From Friend Previous Usage Other ( ) 2. Use of the ...

19 FACTORY SERVICE CENTERS 1-800-4-MAKITA RETAIN THIS PORTION FOR YOUR RECORDS ARIZONA 3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850 CALIFORNIA 41850 Christy St. Fremont, CA 94538-5107 (510) 657-9881 14930 Northam St. La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacrame...

WARNING Some dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Californiato cause cancer, birth defects or other reproductive harm. Some examplesof these chemicals are:• lead from lead-based paints, • crystalline sili...