Lux pspa722 - Manuals - manualsarea.com

Page 2 - COMPATIBILITY

2 UPDOWN PSPA722 LUX PRO PSPA722 1 COMPATIBILITY Your PSPA722 is compatible with most 24 volt: Gas, Oil, or Electric Heating and/or Cooling systems. It cannot beused with 120 volt heating systems, 3 wire zone valves,or Heat Pump S ystems. Ask your dealer for other LUXPRO ® thermostats to control tho...

Page 4 - OPERATING BASICS; HEAT

19. Verify that the system and its fan are operatingproperly. When set to a high temperature, the heatingsystem should provide warm air after a short time.Likewise a cooling system should provide cool air after ashort time. Usually sound from the furnace and airconditioning units can be heard while ...

Page 5 - OVERRIDE; PROGRAMMING; PROGRAM

● Press either the UP or DOWN key. The current modes set temperature will begin to flash. ● Adjust the set temperature as desired. ● After a few seconds the default 2-hour duration will flash in the time area of the display. ● Adjust the duration in 15-minute increments, from between 1 to 4 hours. ●...

Page 6 - ADVANCED FEATURES

● The HEAT SET TEMPERATURE will be displayed on the right side of the display with the HEAT indicator visible. ● Edit the HEAT SET TEMPERATURE, then press NEXT to accept and advance to the COOL SET TEMPERATURE,it will flash to show that it may be edited. ● There is a minimum value that must be maint...

Page 8 - SETUP OPTIONS

Option jumper positions. It then makes all settings andprograms their default values before initiating normaloperation. N O T E: Pressing this button will overwrite your program andinstall the default values of all temperature programs andsetup values into the unit’s nonvolatile memory. To easerepro...

Page 9 - BATTERIES/MAINTENANCE; BATTERY INSTALLATION; 0 TECHNICAL ASSISTANCE

8.3 TEMPERATURE DISPLAY FORMAT(F/C DISPLAY) J5 Temperature may be displayed in Fahrenheit or Celsiuswith this option. 8.4 SMART RECOVERY J6 Smart Recovery allows your HVAC system to attempt torecover from a setback period and reach your desiredcomfort temperature by the beginning of yourprogrammed c...

Page 10 - 2 WIRING DIAGRAMS; WIRING DIAGRAM NOTES; THIS IS A LOW; RC RH C

10 12 WIRING DIAGRAMS WIRING DIAGRAM NOTES 1. Dashed lines are optional.2. Optional common wireallows system to powerthermostat.3. Use “B” or “O” wire - butnot both in heat pumpsystems. Generally neitherare required in aconventional system.4. If “Y” and “C” wires areboth present, then “C” is acommon...

Page 11 - TYPICAL 24V AC 5 WIRE HOOKUP; TYPICAL 24V MULTI-STAGE

11 WIRING DIAGRAM NOTES 1. Dashed lines are optional.2. Optional common wireallows system to powerthermostat.3. Use “B” or “O” wire - butnot both in heat pumpsystems. Generally neitherare required in aconventional system.4. If “Y” and “C” wires areboth present, then “C” is acommon wire.5. If a “B” w...

Page 12 - MERCURY WARNING AND RECYCLING NOTICE:

12 DAY MON MORN DAY EVE NIGHT MORN DAY EVE NIGHT MORN DAY EVE NIGHT TUES WED PERIOD HEAT TIME TEMP. TIME TEMP. COOL DAY THURS MORN DAY EVE NIGHT MORN DAY EVE NIGHT MORN DAY EVE NIGHT MORN DAY EVE NIGHT FRI SAT SUN PERIOD HEAT TIME TEMP. TIME TEMP. COOL 13 USER PROGRAM TABLE To ease reprogramming lat...