LG WD14024D6 - Manuals

5 Important safety instructions To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basicprecautions, including the following: WARNING • Before installation, check for exterior damages. If it has, do not install. • Do not install or store the washer where i...

6 Important safety instructions ■ Basic safety precautions ■ Save these instructions To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basicprecautions, including the following: WARNING Improper connection of the equipment-grounding conductor can result i...

7 Specifications 란 제 리 Spanner Inlet hose: Hot/Cold(2EA) ■ Accessories Drawer (For detergent and fabric softener) Drain hose Transit bolts Power plug Control panel Drain pump filter Lower cover cap • If the supply cord is damaged, it must be replaced by themanufacturer or its service agentsor a simi...

8 Installation ■ Removing packing 1 . Remove the cardboard box and styrofoam packing. 2 . Lift the washing machine and remove the base packing. This will require 2 ormore people or a lifting device. 3 . Remove the tape securing the power supply cord and drain hose. 4 . Remove the inlet hoses from th...

9 Installation Washer approx. 2cm • Level floor : Allowable slope under entire washer is 1˚. • Power outlet : Must be within 1.5 meters of either side of locationof washer. Do not overload the outlet with morethan one appliance. • Additional Clearance : For Wall, 10cm:rear / 2cm : right & left s...

10 Installation • Do not use an extension cord or double adapter. • If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. • Always unplug the machine and turn off the water supply after use. • Connect th...

11 Installation 1 . Unscrew the adapter ring plate and the 4 adapter retaining screws. 2 . Push the adapter onto the end of the tap so that the rubber seal forms awatertight connection. Tighten theadapter ring plate and the 4 screws. 3 . Push the water supply hose vertically upwards so that the rubb...

12 1 . Unscrew the adapter ring plate and the 4 adapter retaining screws. 2 . Remove the guide plate if the tap is too large to fit the adapter. 3 . Push the adapter onto the end of the tap so that the rubber seal forms a watertight connection. Tighten the adapter ring plate and the 4 screws. 4 . Pu...

13 Installation Installation of drain hose • The drain hose should not be placed higher than 100 cm above the floor.Water in the washer does not drain ordrains slowly if above this height. • Securing the drain hose correctly will protect the floor from damage due towater leakage. • If the drain hose...

14 2. If the floor is uneven, turn the adjustablefeet as required (do not insert pieces ofwood etc. under the feet).Make sure that all four feet are stable andresting on the floor and then check thatthe appliance is perfectly level (use a spiritlevel). 1. Leveling the washing machine properlyprevent...

15 Installation ‹ Concrete floors ‹ Wooden floors (Suspended floors) • The installation surface must be clean, dry and level. • Install washer on a flat hard floor. ‹ Tile floors (Slippery floors) • Position each foot on the Tread Mate and level the machine to suit. (Cut Tread Mate into 70x70 mm sec...

16 How to use washer Operating washing machine 2 . Open the door and load laundry. 1 . Sort Laundry. (Refer to 17 page) 3 . Press the Power button. 4 . Select a Program. (Refer to 18~20 page) 5. Add detergent.(Refer to 26~27 page) 6 . Press the Start/Pause button. Select options at this time(Refer t...

17 How to use washer ■ Care before washing 3 . Caring before loading Combine large and small items in a load. Load largeitems first. Large items should not be more than half thetotal wash load. Do not wash single items. This may cause an out-of-balance load. Add one or twosimilar items. • Check all ...

18 How to use washer Washing program table • Recommended courses according to the laundry type. Cotton Eco Easy Care Mix Provide optimized washingperformance with less energyconsumption. This cycle is suitable for casualshirts that do not need ironing afterwashing. Enables various fabrics to bewashe...

19 How to use washer • Neutral detergent is recommended. • The wool cycle features gentle tumbling and low-speed spin for garment care. NOTE Extra options * : This option is automatically included in the cycle and can not be deleted.** : This option is automatically included in the cycle and can be ...

20 How to use washer Operating data 1400 1400 1000 1400 1000 1000 1400 1000 800 1400 800 800 1400 1400 Max RPM Cotton Cotton Eco Easy Care Mix Baby Care Silent Wash Skin Care Duvet Sports Wear Dark Wash Delicate Wool Quick 30 Intensive 60 Program

22 How to use washer • The delay time is the time to the end of the programme, not the start. The actual running time may vary due towater temperature, wash load and otherfactors. NOTE 1 . Press the Power button. 2 . Select a cycle. 3 . Touch the Time Delay button and set time required. 4 . Press th...

24 How to use washer The Beep on/off function can be set only during the washing cycle. 1 . Press the Power button. 2 . Press the Start/Pause button. 3 . Touch and hold the Temp. and Rinse button simultaneously for three seconds to set Beepon/off function. Once the Beep on/off function is set, the s...

25 How to use washer Tub Clean is a special cycle to help clean the inside of the washing machine. A higher water level and higher spin speed is used in this cycle. Perform this cycle regularly. 1 . Remove any clothing or items from the washer and close the door. 2 . Open the dispenser drawer and ad...

26 Adding detergent • Main wash only ➔ • Pre Wash + Main Wash ➔ • Do not exceed the maximum fill line. Overfilling can cause early dispensing of thefabric softener which could stain clothes. Close the dispenser drawer slowly. • Do not leave the fabric softener in the detergent drawer for more than 2...

27 Adding detergent • Detergent should be used according to the instruction of the detergent manufacture.• If too much detergent is used, too many suds can occur and this will decrease the washing result or cause heavy load to the motor. • It is recommended that you use powdered detergent for best r...

28 Maintenance The water inlet filter • " " icon will be displayed on the control panel when water does not enter the detergent drawer. • If water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.It is therefore a good idea to clean it from time to t...

29 Maintenance • Allow the water to cool down before cleaning the drain pump, carrying out emergency emptying or opening the door in an emergency. • The drain filter collects threads and small objects left in the laundry. Check regularly that the filter is clean to ensure smooth running of your mach...

30 Maintenance Dispenser drawer • After a while, detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downwards and by pulling it out. • ...

31 Maintenance • Proper care of your washer can extend its life.• The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. • Immediately wipe off any spills. Wipe with damp cloth.• Try not to hit surface with sharp objects.• Do not use methylated spir...

32 Troubleshooting guide • This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately.When the machine does not function properly or does not function at all, check thefollowing points before you contact your service pr...

34 Troubleshooting guide Symptom Possible Cause Solution • Water supply is not adequate in area.• Water supply taps are not completely open.• Water inlet hose(s) are kinked.• The filter of the inlet hose(s) are clogged. • Drain hose is kinked or clogged.• The drain filter is clogged. • Load is too s...

35 Troubleshooting guide • Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning except to the callcenter. • SMARTDIAGNOSIS™ cannot be activated if the washer does not power up. If this happens, then troubleshooting...