Lennox 506033-35 - Manuals

Lennox 506033-35 – Manual in PDF format online.

Manuals:

Manual

Manual Lennox 506033-35

Summary

Page 2 - Figure 2; INSTALLATION INSTRUCTIONS; Removing Existing Blower From Stove; allen screws from blower, and remove blower from stove. See; Figure 3; Fan nut is; Figure 4; Step 7. Strip blower wires and connect butt connectors to both. See; Figure 6

2 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Figure 2 Stove Back Blower INSTALLATION INSTRUCTIONS Removing Existing Blower From Stove Step . UNpLUG pOWER CORD AND ENSURE AppLIANCE IS COLD Step 2. Using a 5/32 allen wrench/T-handle, remove the blower mounting allen screws from blower, and r...

Page 3 - Step 9. Placing edge of wire loom at edge of blower cage, connect the; black blower lead wires to the wires on the blower harness, using; Figure 9; Step 0. Reconnect the new ground wire to the motor stud. See Figure; Step . Slide the heat shrink tube to the motor, covering wires and con-; Crimp on butt connectors to both wires

3 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Figure 7 Step 8. Slide the supplied 6” of 3/4” heat shrink tube over the (3) blower harness wires. See Figure 8. Figure 8 Step 9. Placing edge of wire loom at edge of blower cage, connect the black blower lead wires to the wires on the blower ha...

Page 4 - Figure 16 - This increased opening between the pedestal and; Firebox; WOODSTOVES WITh pEDESTAL BASE; Leg based units, see instructions on; Back View of Pedestal; Bolts; Step 3. Secure wires in the heat shrink tube to the fan cage using (3); Step 5. Reinstall the blower assembly as shown in Figure 2 and the; over tighten as you may strip the holes out.; Wires / heat Shrink Tube

4 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Step 3. Insert snap switch bracket mounting tabs between the pedestal and the firebox bottom. See Figure 17. Figure 16 Step 2. Insert a large flat head screwdriver or pry bar into the small open- ing between the pedestal mounting flange and the ...