Kidde PI 2000 - Manuals

Kidde PI 2000 – Manual in PDF format online.

Manuals:

Manual Kidde PI 2000

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7

Summary

Page 2 - CONTENTS OF THIS MANUAL; RECOMMENDED LOCATIONS FOR ALARMS; • Locate at least one alarm on every floor level.; MOBILE HOME INSTALLATION; DIAGRAM “B”; DIAGRAM “C”

The ion portion of this alarm detects products of combustion using the ionization technique. It con-tains 0.9 microcurie of Americium 241, a radioactive material. Distributed under U.S. NRC License No.32-23858-01E. Manufactured in compliance with U.S. NRC safety criteria in 10 CFR 32.27. Thepurchase...

Page 3 - WIRING REQUIREMENTS; INTERCONNECT WIRING DIAGRAM; BATTERY INSTALLATION; FIGURE 1

2. LOCATIONS TO AVOID • In the garage. Products of combustion are present when you start your automobile. • Less than 4” (10cm) from the peak of an “A” frame type ceiling. • In an area where the temperature may fall below 40ºF or rise above 100ºF. • In dusty areas. Dust particles may cause nuisance ...

Page 4 - FIGURE 2. SELECT CORRECT MOUNTING HOLES ON TRIM RING; FIGURE 3; Posts; OPERATION AND TESTING; Standby Condition; The red LED will flash every 2 seconds as long as the alarm in Hush.; Low Battery Condition

5. If you have finished all the WIRING, BATTERY INSTALLATION AND TRIM RING MOUNTING STEPS, you can install the alarm on the trim ring. Note: The alarm will mount to the trim ring in 4positions (every 90 degrees). 6. Install the alarm on the trim ring and rotate the alarm in the direction of the “ON”...

Kidde Manuals