Kicker RS56.2 - Manuals - manualsarea.com

Page 2 - ALWAYS KEEP YOUR RECEIPT!

2 Introduction RS-Series System Components Owner’s Manual Models: RS65.2 / RS56.2 RS-Series System Components Attention: Please record your purchase information in the area below. We recommend attaching the original sales receipt to this manual for future reference. If you require service on this sp...

Page 3 - tures; Features

3 F e a tures Features CIMP ™ (Curvilinear Injection-Molded Polypropylene Woofer Cones) is a high performance composite, which remains rigid, minimizes cone flex and lowers harmonic distortion. The CIMP ™ consists of a one-piece, injection- molded polypropylene material that moves as a piston, exhib...

Page 4 - Performance

4 Specifica tions Performance Model: RS56.2 RS65.2 Speaker Design Rated Impedance, ohm DC Resistance, ohm Sensitivity [SPLo], dB @ 1W, 1m Power Range, Watts RMS Peak Power Handling, Watts Effective Frequency Range, Hz Top-Mount Depth, in (cm) Bottom-Mount Depth, in (cm) Mounting Hole Diameter, in (c...

Page 5 - Installation; Mounting; we recommend using genuine Kicker Accessories and Wiring.

Installa tion 5 Installation Your Kicker RS-Series System Component drivers are specifically designed for mounting in free-air applications. The speakers do not require a sealed enclosure for optimum performance. It is important to isolate the sound coming off the front of the driver from thesound r...

Page 6 - Figure 1 Figure 2; Installa

Installation Push Grill into place andsnap onto Speaker Figure 1 Figure 2 To Crossover Stagger Holes For Wiring & Use Grommets (When Factory Holes and Grommets are not Available) (Optional) Door Panel Kick Panel If custom door mounting locations for the RS-Series System Components are desired, b...

Page 7 - Door Body; Tweeter Mounting

Installation Door Body Tweeter Mounting Nut 2" Hole Door Panel Clearance Hole 2.5" Figure 3 (Flush Mount) Tweeter Mounting The tweeter can be mounted one of four ways: flush, surface, angled and coaxial mounting. For flush mounting applications, please refer to the illustration in Figure 3. ...

Page 8 - Tweeter Mounting continued; Figure 4

8 Installa tion Installation Tweeter Mounting continued The tweeter can be mounted in the center of the midrange. This creates a high quality coaxial speaker. Remove the tweeter face plate by screwing it off and install the supplied smaller face plate. Remove the magnet boot from the midrange. Then ...

Page 9 - Wiring Options; Tweeter; SOURCE UNIT or AMPLIFIER

Wiring Options Installa tion 9 There are three sets of wires supplied with the Kicker RS-Series System Components. One set is designed to plug on to the terminal of the midrange. The other end of this wire goes to the midrange output on the supplied crossover. The other two sets of wires do not have...

Page 10 - Wiring two RS-Series System Components to a single channel; Figure 6

Installa tion Wiring Options 10 RS-Series System Components Wiring two RS-Series System Components to a single channel Modern high performance system components have a lower DC Resistance than what used to be available. The Kicker RS-Series System Components are rated at four ohms and work with any ...

Page 11 - WHAT TO DO IF YOU NEED WARRANTY OR SERVICE; Please use common sense when controlling volume!; Warran

Acoustics LIMITED WARRANTY WHAT IS NOT COVERED? Kicker warrants this product to be free from defects in material and workmanship under normal use for a period of THREE (3) MONTHS from date of original purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for ONE (1) ...