Page 2 - Table of Contents
Table of Contents Important Safety Information 3 Before You Start 4 Assembly 5-7Warm Up Exercises 8 Moving Instructions 9 Power Requirements 10 Console Panel Functions 11-12 Program and Operation 13-14 Belt Adjustment 15 Maintenance Instructions 16 Troubleshooting Guide 17 Error Messages 18 Parts Li...
Page 3 - Important Safety Information
Important Safety Information WARNING! Before using this treadmill or starting any exercise program, consult your physi- cian. This is especially important for persons over the age of 35 and/or persons with pre-existing health problems. The manufacturer or distributor assumes no responsibility for pe...
Page 4 - Before You Start
Before You Start Thank you for purchasing the HEALTH TRAINER 403T Treadmill! This quality product you have chosen was designed to meet your needs for cardiovascular exercise. Before you start, please read the Owner's Manual and become familiar with the operation of your new treadmill. Remember to ta...
Page 5 - Assembly
Assembly The HEALTH TRAINER 403t treadmill will require assembly before operating. After opening the box, remove any packing material from the treadmill. Do not throw away any packing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electrical cor...
Page 7 - CONSOLE
Assembly 7 Figure 4: Top Rail Assembly 4. Attach the top rail to the left and right uprights using two Allen Bolts M5*15 (# 26) and two Arc Washers (#41).You may now firmly tighten all hardware. Refer to Figure 4. Note: Be careful not to pinch the wire har- ness. 5. Remove the four M5*20mm screws fr...
Page 8 - Warm Up Exercises; TOE TOUCH STRETCH
Warm Up Exercises TOE TOUCH STRETCH Stand bending your knees slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible. Hold for 15 counts, then relax. This will stretch your hamstrings, back of knees, and back. HAMS...
Page 9 - Moving Instructions
Moving Instructions Caution! To avoid the risk of injury, never attempt to move the treadmill while it is in the unfolded operating position. To reduce the possibility of injury while lifting, bend your legs and keep your back straight. As you raise the treadmill, lift using your legs, not your back...
Page 10 - Power Requirements
Power Requirements IMPROPER CONNECTION OF THE EQUIPMENT GROUNDING CONNECTOR CAN RESULT IN A RISK OF AN ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE MAN IF YOU ARE IN DOUBT AS TO WHETHER THE PRODUCT IS PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE PRODUCT IF IT WILL NOT...
Page 11 - Console Overview; CONSOLE FUNCTIONS
Console Overview CONSOLE FUNCTIONS There is one display windows on the control panel to provide feedback information. This win-dow will display information on the following functions: TIME Indicates elapsed time after pressing start in minutes and seconds (0-99 minutes, 0-59 seconds). SPEED Indicate...
Page 12 - CONSOLE BUTTONS
Console Overview CONSOLE BUTTONS There are 8 Console button. POWER: Used to turn unit off and on. START: Used to start unit. STOP: Used to stop unit. RESET: Used to reset values in display window. PROGRAM: Used to toggle thru five preset programs. MODE: Used to toggle thru different modes. SPEED +/-...
Page 13 - Program and Operation
Program and Operation MODE OVERVIEW This treadmill has 5 different exercise modes. Following as a brief overview and instruction for each mode. MANUAL MODE: Allows user to manually adjust Speed with + or - button. Time, Calories and Distance count up from 0. To use Manual Mode, Attach safety key. Pr...
Page 15 - Belt Adjustment
Belt Adjustment WARNING! Do not over-tighten rollers! This will cause premature roller bearing failure! Belt adjustment and tension performs two functions: adjustment for tension and centering. Your new treadmill comes pre-adjusted from the factory for tension and cen-tering. Please follow the proce...
Page 16 - Maintenance Instructions
Maintenance Instructions WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from the surge protector. CLEANING Routine cleaning of your HT403T Fitness treadmill will extend the life of your treadmill. WARNING! To prevent electrical shock, be sure the power to ...
Page 17 - Troubleshooting Guide; Treadmill will not start; Treadmill loses power during use.; Treadmill walking belt slows during use
Troubleshooting Guide Treadmill will not start . 1. Is the Safety Key inserted into the treadmill Console? 2. Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet, and the surge protector is turned on. (Refer to “Power Requirement...
Page 18 - Error Messages; Treadmill Error Messages
Error Messages Treadmill Error Messages Your treadmill is equipped with a software package that enables error messages to be dis-played when there is a problem. The following error codes will be displayed in the console dis-play windows. Error Messages Er-1 - The console to motor controller communic...
Page 19 - Parts List
Parts List Ref # Part # Description Qty Ref # Part # Description Qty 1 423-00046 TOP RAIL, HT403T 1 33 402-00031 PHILIP SCREW ST4.2*13 4 2 423-00045 LEFT UPRIGHT, HT403T 1 34 402-00019 PHILIP SCREW ST4.2*13 2 3 423-00044 RIGHT UPRIGHT, HT403T 1 35 402-00016 PHILIP SCREW ST4.2*13 10 4 423-00047 BASE ...
Page 20 - Exploded View
Exploded View 20 1 2 3 4 5 6 7 01 9 8 11 11 21 31 41 51 61 71 81 91 9 60 1 02 12 22 26 26 84 05 15 25 35 45 55 65 7 61 62 5 85 95 32 42 52 62 72 82 92 03 13 23 33 43 53 63 73 83 93 04 14 24 34 44 54 64 74 84 94
Page 21 - Warranty Information
Warranty Information HT403T Treadmill designed and distributed by KEYS FITNESS PRODUCTS, LP – LIMITED WARRANTY PLEASE CONSULT YOUR PHYSICIAN BEFORE USING THIS PRODUCT. This Limited Warranty applies in the United States and Canada to products manufactured or distributed by Keys Fitness Products, LP (...