Kenwood KDC-C667- Manuals

Control unitChanger switchingunitO-N switch setting Warning / Safety precautions The marking of products using lasers(Except for some areas) The label is attached to the chassis/case andsays that the component uses laser beams thathave been classified as Class 1. It means thatthe unit is using laser...

■ Accessories A × 1 B × 4 C × 4 D × 1 E × 1 ■ Removing the transportation screws Remove all 3 transportation screws for protecting theinternal mechanism before you start to install the unit. After removing the transport screw, retain it carefully andattach it again before transporting the unit again...

■ In case of hanging in the trunk 90 0 45 90 0 45 90 0 45 90 0 45 90 0 45 90 0 45 90 0 45 90 0 45 KDC-C667 KDC-C717 Use the holes marked ● to install the unit. Do not tighten the screw B too securely at the time of installation, but tighten it securely after having fixed the bracket A . 2 CAUTION ■ ...

Warning /Avertissement /Advertencia /Advertência The marking of products using lasers(Except for some areas) The label is attached to the chassis/case andsays that the component uses laser beams thathave been classified as Class 1. It means thatthe unit is using laser beams that are of aweaker class...

Safety precautions Take the following precautions to prevent fire andavoid personal injury : • Check that no metal objects (coins, tools, etc.) are left inside the unit to avoid short circuits. • If you smell or see smoke, turn the power off immediately and consult your Kenwood dealer. Take the foll...

Précautions de sécurité Pour éviter tout risque de feu et de blessuresphysiques, observer les précautions suivantes: • Vérifier que l’on n’a pas laissé d’objets métalliques (pièces de monnaie, outils, etc.) à l’intérieur del’appareil, afin d’éviter les courts-circuits. • Lors d’un dégagement d’odeur...