Keating 2000 - Manuals - manualsarea.com

Page 2 - FOR YOUR SAFETY; Purchaser should post in a prominent location instructions to; WARNING

i Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. FOR YOUR SAFETY Do not store oruse gasoline orother flammablevap...

Page 3 - IF EQUIPMENT ARRIVES DAMAGED; FIRST STEPS; MINIMUM CLEARANCE; SUITABLE FOR COMBUSTIBLE FLOORS VENTI-

INTRODUCTION Instructions in this manual should be read thoroughlybefore attempting to operate this Keating Gas Fryer. Allinstallation and service on Keating equipment must beperformed by qualified, certified, licensed and/or autho-rized installation or service personnel. Operating information for K...

Page 4 - GAS CONNECTIONS AND PIPE SIZE; Line pressure must be kept; FLEXIBLE GAS CONNECTORS AND QUICK DIS-; For an appliance equipped with casters:; RESTRAINING DEVICES; ) Adequate means must be provided to limit the; INSTALLATION; ELECTRICAL CONNECTION

2 only on the type of gas specified by the user and indi-cated on the serial plate located inside the door. Thegas may be natural, propane or manufactured. Thetype of gas cannot be converted to another gas fuel byturning or engaging a switch. GAS CONNECTIONS AND PIPE SIZE A single Keating Gas Fryer ...

Page 5 - LEVELING; PLACING KEATING GAS; a. Maximum incoming gas pressure; NEVER move a fryer when full of oil.; FILLING; Before filling the fryer make certain the fryer; LIGHTING INSTRUCTIONS

3 receptacle. Do not cut or remove the grounding prongfrom this plug. (Model AA has no electric connection). LEVELING The Keating Gas Fryer will operate at its highest effi-ciency when properly leveled. Place a level on the fryerfrom side to side. For fryer on legs, the bottom foot ofthe leg is adju...

Page 6 - AA MODELS OPERATING INSTRUCTIONS

4 AA CONTROL PANEL BB CONTROL PANEL 34×24 BB CONTROL PANEL 34×24 TS CONTROL PANEL TS CPU CONTROL PANEL AIR IN THE GAS SUPPLY LINE MAY REQUIRE ALONGER THAN NORMAL PERIOD OF TIME TOLIGHT YOUR FRYER DURING INITIAL INSTALLA-TION OR AFTER OVERNIGHT SHUTDOWN NOTE: Unless you have an AA model your fryer ca...

Page 7 - TS MODELS OPERATING INSTRUCTIONS; SHUTDOWN PROCEDURE; COOKING

STEP 1. Set "MELT-IDLE-FRY" switch to "IDLE" posi- tion and thermostat to the "OFF" position. STEP 2. Turn "MAIN POWER" switch to the "ON" position. STEP 3. Hold the "PUSH TO LIGHT" switch in until the amber "PILOT ON" light comes on. STEP 4. S...

Page 8 - Set thermostat to the desired frying temperature.; SHUTDOWN INSTRUCTIONS; DRAINING; CLEANING AND BOIL-OUT FOR A

6 C CA AU UT TIIO ON N OPERATION OF THIS FRYER SHOULD BE LIMITEDTO PERSONNEL WHO HAVE BEEN THOROUGHLYTRAINED IN OPERATING PROCEDURES. Set thermostat to the desired frying temperature. C CA AU UT TIIO ON N CARE SHOULD BE TAKEN WHEN LOWERINGBASKETS INTO FRYER TO PREVENT SPLASHINGHOT OIL FROM FRYER VES...

Page 9 - DO NOT MIX WATER AND HOT OIL; CLEANING AND BOIL-OUT FOR A FRYER WITH; COVERED RECEPTACLE

C CA AU UT TIIO ON N A KEATING FRYER OR FILTER SHOULD BE DRAINEDONLY UNDER THE SUPERVISION OF PROPERLYTRAINED PERSONNEL. WHEN DISCARDING OIL, ACOVERED RECEPTACLE APPROVED FOR USE WITHHOT OIL SHOULD BE USED. USE OF A NON-APPROVED RECEPTACLE OR METHOD OF DRAININGTHE OIL COULD JEOPARDIZE THE SAFETY OF ...

Page 10 - OPERATOR SELF HELP; NOTE; OCCURRENCE

8 5. Open the discard valve located near the quick dis- connect in the filter cabinet. 6. The hose may now be used to pump the oil into the shortening handling system and discarded proper-ly. 7. Remove oil container to a secure area to prevent accidental spillage. 8. Fill fryer vessel to “Fill Level...

Page 11 - PREVENTIVE MAINTENANCE; PREVENTIVE MAINTENANCE CHART; THERMOSTAT CALIBRATION; BEFORE REPLACING, TEST THERMOSTATS; Overshoot; Thermostat Bulb Positioning 10x11, 18 & up Fryer Gas; QUALIFIED SERVICE; PERSONNEL ONLY

PREVENTIVE MAINTENANCE Preventive maintenance should be done in daily, week-ly, monthly and yearly intervals as necessary. Followingpreventive maintenance procedures will help keep yourfryer working efficiently. Proper care and servicing willlead to years of quality performance. PREVENTIVE MAINTENAN...

Page 12 - “KEATING” ELECTRONIC TIMER; Note

REQUIRED TEST EQUIPMENT: Multimeter (for testing continuity) CHECKING CONTINUITY WITH THE MULTIMETER 1. Rotate the thermostat shaft until an audible click is heard. 2. Rotate the thermostat shaft left and right ten times causing the switch to click on and off ten times,while using the Multimeter to ...

Page 13 - OPTIONAL TIMER; DIGITAL TIMERS; WARRANTY REPAIRS; ORDERING PARTS; PARTS LIST; CONTROL PANEL AA GAS; Corresponds with parts list on page 12

STEP 2 PRESS all 3 buttons in sequence: left-center-right.The BEEPER will BEEP when each button ispressed. If BEEPER does not BEEP, the timer isdefective. STOP TESTING. Reset procedure iscompleted when 1:00 appears on the digital dis-play. OPTIONAL TIMER OPERATING INSTRUCTIONS PART # 056921 DIGITAL ...

Page 14 - CONTROL PANEL BB GAS; CONTROL PANEL TS GAS

QTY. DESCRIPTION PART # A 1 THERMOSTAT DIAL PLATE 375° 058037 B 1 THERMOSTAT KNOB 004163 C 1 GAS FRYER THERMOSTAT 14” 14CM and AA 023145 10x11 18 and up 035553 D 1 SWITCH ROCKER WHITE ON/OFF 035030 E 1 SWITCH ROCKER MOMENTARY 032297 F 1 HIGH LIMIT (RESETTABLE)GAS 034357 CONTROL PANEL BB GAS QTY.DESC...

Page 18 - BB ELECTRICAL ASSEMBLY WITH SE FILTER

16 Electrical Assembly not shown to scale TS2000 ELECTRICAL ASSEMBLY Electrical Assembly not shown to scale BB ELECTRICAL ASSEMBLY WITH SE FILTER

Page 22 - KEATING LIMITED WARRANTY CARD; SERVICE INFORMATION; Have your serial and model number available when ordering parts.

KEATING LIMITED WARRANTY CARD PLEASE COMPLETE AND MAIL AT ONCE–WARRANTY IS NOT IN EFFECT UNTIL CARD IS RETURNED. WARRANTY CARD IS ALSO AVAILABLE TO COMPLETE ON LINE AT YOUR CONVENIENCE. COMPANY: _________________________________________________________________________________________________________...