Jet OES-80CS - Manuals

8 Assembly Stand Assembly Referring to Figure 1: 1. Remove all contents from the shipping container. 2. Clean all rust protected surfaces with a mild solvent. Do not use paint or lacquer thinner, gasoline, or mineral spirits; these will damage painted surfaces. 3. Attach the four rubber pads (A) to ...

9 Referring to Figure 3: 4. The sanding platen (A) is presently in the horizontal position. Pull lock handle (B) forward to unlock the platen assembly. 5. Tilt sanding platen to the vertical position (C), which will look like D in Fig. 4; then push the lock handle (B) to lock the platen assembly in ...

11 Electrical Grounding Instructions This sander must be grounded while in use to protect the operator from electric shock. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with ...

12 Extension Cords Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your machine will draw. An undersized cord will cause a drop in the line voltage resulting in power loss and overheating. Table 1 shows the correc...

15 Basic Operations Removing the belt guard exposes more of the sanding belt! Replace the belt guards immediately after completing any sanding that requires its removal! Failure to comply may cause serious injury! Horizontal Sanding For horizontal sanding , the platen is locked in the horizontal pos...

16 Contour Sanding Referring to Figure 19: Contour sanding is done from the extension table mounted on the motor where the sanding belt wraps around the drive drum (D). To set up the sander for contour sanding: 1. Loosen the two lock knobs (C) that secure the drum guard & dust port (E). 2. Swing...

17 Troubleshooting Operating Problems Trouble Possible Cause Solution Sander will not start 1. Sander unplugged from wall or motor 2. Fuse blown or circuit breaker tripped 3. Cord damaged 1. Check all plug connections 2. Replace fuse or reset circuit breaker 3. Replace cord Sanding belt does not com...

18 Table and Motor – Parts Index No. Part No. Description Size Qty. 1............... EHVS80CS-01 .........Base...................................................................................................... 1 2............... EHVS80-02N ...........Push Button Switch ..............................

19 Table and Motor – Parts Index No. Part No. Description Size Qty. 53............. OES80CS-153 .........Pin......................................................................................................... 2 54............. EHVS80-67..............Motor Cord .....................................

21 Idle Drum – Parts Index No. Part No. Description Size Qty. 1............... OES80CS-201 .........Tension Bar ........................................................................................... 1 2............... OES80CS-203 .........Spring.....................................................