Jasco 51209 - Manuals - manualsarea.com

Page 3 - Motion Sensing Alarm; Low Battery Indicator; The Motion Sensing Alarm has a low; Wall

Motion Sensing Alarm With Remote Control Low Battery Indicator The Motion Sensing Alarm has a low battery indicator light. When the batteries need to be replaced, the indicator will flash slowly. Average battery life for typical usage is up to one year. Wall Mount Alarm/Chime Switch Motion Sensing A...

Page 4 - INSTALLING BATTERIES; The battery compartment is located on

INSTALLING BATTERIES The battery compartment is located on the back of the unit. Remove the battery compartment screw and slide off cover in the direction of the open arrow.Insert (3) AA batteries (not included) . Take care to note the polarity diagram inside the battery compartment . Replace the co...

Page 5 - CREATING YOUR PERSONAL ALARM CODE; The -digit keypad allows you to set a; INSTALLATION; The alarm is designed to be wall mounted

CREATING YOUR PERSONAL ALARM CODE The -digit keypad allows you to set a personal code for arming and disarming the alarm. Remove the battery compartment screw and slide off cover in the direction of the open arrow. Press the LEARN button once; the red indicator light on the front of the alarm will b...

Page 7 - OPERATING IN THE ALARM MODE

7 Secure ball and socket mount to the wall using either the provided wall anchors or by screwing directly into a wall stud. Once installed securely on the wall, slide insert bracket of mount into the back of the unit and lock in place. The mount will click when secured to the alarm. OPERATING IN THE...

Page 8 - Slide switch to ALARM mode.; Arming the Alarm

8 Slide switch to ALARM mode. Arming the Alarm Arm the alarm by pressing your -digit code. A beep will sound after each button is pressed. When the -digit code is entered correctly the unit’s indicator light will flash green once. If entered incorrectly, the unit will sound and the indicator light w...

Page 9 - Disarming the Alarm; The unit will beep once if motion is sensed.

in 30 seconds. The siren will sound for 30 seconds (unless disarmed by the remote) and then turn off. In 1 seconds the alarm will check for motion. If motion is detected, the siren will sound again. The cycle will repeat until the unit is disarmed with the remote. Disarming the Alarm When returning ...

Page 11 - To clean the unit housing, use a soft cloth

11 Deactivating the Chime: To deactivate the chime, slide the switch to ALARM. TESTING MOTION SENSOR OPERATION Set alarm to CHIME mode; the chime will sound once.After initial chime, wait 1 seconds and wave hand in front of the sensor. If chime sounds immediately, sensor is working correctly. To tur...

Page 12 - WARNING; Limitations of Alarm Products

12 WARNING Limitations of Alarm Products This product should be tested periodically to make sure it is working properly. The product, if used properly, may reduce the risk of burglary, robbery, or other adverse events. However, JASCO is not an insurer, this product is neither insurance nor a guarant...