InFocus EC 10SB (SL) - Manuals

Page 2 - — C O N T E N T S —; SAFETY; OPERATION AND MAINTENANCE; IMPORTANT INFORMATION; WARNING; NOTE

— 2 — — C O N T E N T S — Page IMPORTANT INFORMATION ............................... 2 MEANINGS OF SIGNAL WORDS ........................ 2 SAFETY IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE COMPRESSOR ........ 3 REPLACEMENT PARTS ........................................ 5 GROUNDING INSTRUCTIONS ......

Page 3 - READ ALL INSTRUCTIONS

— 3 — SAFETY IMPORTANT SAFETY INSTRUCTIONSFOR USE OF THE COMPRESSOR WARNING: Death or serious bodily injury could result from improper or unsafe use of compressor. To avoid these risks, follow these basic safety instructions: READ ALL INSTRUCTIONS 1. NEVER TOUCH MOVING PARTS. Never place your hands,...

Page 6 - EXTENSION CORD; SAVE THESE INSTRUCTIONS

— 6 — EXTENSION CORD Use only three-wire extension cords that have three-prong grounding-type plugs and three-pole receptacles that accept thecompressor’s plug. Replace or repair damaged cord.Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy e...

Page 7 - OPERATION AND MAINTENANCE; NAME OF PARTS

— 7 — OPERATION AND MAINTENANCE NOTE : The information contained in this Instruction Manual is designed to assist you in the safe operation and maintenance ofthe compressor. Some illustrations in this Instruction Manual may show details or attachments that differ from those on your owncompressor. NA...

Page 8 - Accessory other than these shown; STANDARD ACCESSORY; Never use compressor for

— 8 — PRIOR TO OPERATION 1. Power source Ensure that the power source to be utilized conformsto the power source requirements specified on theproduct nameplate. 2. Power switch Ensure that the knob of the pressure switch is in the“OFF” position (Fig. 2). If the plug is connected to areceptacle while...

Page 9 - Drain tank to release air pressure; Right running position; TRANSPORT; Adjustment of working pressure

— 9 — 4. Confirm the power receptacle If the power receptacle only loosely accepts the plug,the receptacle must be repaired. Contact the nearestelectric store for repair service.If such a faulty receptacle is used, may causeoverheating, resulting in a serious hazard. 5. Dipstick insertion and oil le...

Page 10 - MAINTENANCE; Disconnect the compressor from the; Cleaning the intake filter; Never clean filter element with a

— 10 — Fig. 5 3. Shutdown (1) Push the knob of the pressure switch to “OFF” (Refer to Fig. 1 and Fig. 2). (2) Unplug the plug from power source.(3) Open the drain cock located at the lower part of the tank (Fig. 6). MAINTENANCE WARNING: Disconnect the compressor from the power source and remove thec...

Page 11 - SERVICE AND REPAIRS

— 11 — Fig. 8 Pour oil into the hole of the dipstick.To the level indicated on the dipstick (Refer to Fig.4).For oil replacement, follow the table below. OIL TYPE SAE 5W50 SYNTHETIC OIL (–20°+120°F) For both summer and winter use SAE 10W40 MULTI-GRADED OIL (+50°+120°F) For warm weather use only (2) ...