Hilti 3565225 - Manuals - manualsarea.com

Page 3 - English; Contents

English 1 Contents 1 Information about the documentation . . . . . . . . . . . . . . . . . . . . . . 2 1.1 About this documentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.2 Explanation of symbols used . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.2.1 Wa...

Page 5 - Safety

English 3 Item reference numbers are used in the overview illustration and refer to the numbers used in the key in the product overview sec- tion. This symbol is intended to draw special attention to certain points when handling the product. 1.3 Product-dependent symbols1.3.1 Symbols on the product ...

Page 14 - Technical data

12 English Note Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds after releasing the control switch. If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting section. 3.5 Indication of overloading and ove...

Page 16 - A falling power tool may present a risk of injury to; Note; The belt hook allows the power tool to be attached to a belt worn by

14 English 5.2 Removing the battery ▶ Remove the battery. 5.3 Fitting and adjusting the side handle ▶ Fit the side handle. 5.4 Fitting the belt hook (optional) WARNING Risk of injury. A falling power tool may present a risk of injury to yourself and others. ▶ Check that the belt hook is fitted secur...

Page 17 - Fit the mounting plate into the guides provided.; Fitting or removing the drill bit; Fit the drill bit into the chuck or remove it from the chuck.; Fitting or removing the bit adapter / bit

English 15 ▶ Fit the mounting plate into the guides provided. 5.5 Fitting or removing the drill bit ▶ Fit the drill bit into the chuck or remove it from the chuck. 5.6 Fitting or removing the bit adapter / bit ▶ Insert the bit adapter in the chuck and then turn the chuck sleeve until tight. Printed:...

Page 21 - Troubleshooting

English 19 ▶ Remove the battery. ▶ Transport the tool and battery individually packaged. ▶ Never transport batteries in bulk form (loose, unprotected). ▶ Check tools and batteries for damage before use after long periods of transport. Storage CAUTION Inadvertent damage caused by defective battery. A...

Page 22 - Disposal

20 English Trouble or fault Possible cause Action to be taken 1 LED blinks. The drill / driver doesn’t work. The battery is too hot. ▶ Bring the battery to the recommended op- erating temperature. Hammer drilling is not possible. The operating mode is not set correctly at the selector ring. ▶ Set th...

Page 23 - 0 Manufacturer’s warranty; Please contact your local; Hilti; representative if you have questions about

English 21 10 Manufacturer’s warranty ▶ Please contact your local Hilti representative if you have questions about the warranty conditions. Printed: 01.02.2017 | Doc-Nr: PUB / 5329076 / 000 / 00