Hayter 446E - Manuals

Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the originalmachine manufacturer. 110-7058 1. Height of cut 110-7059 Model 447E only 1....

Setup Unfolding the Handle 1. Unlock the handle locks, move the handle sections into the operating position, and lock the handle locks(Figure 3). Figure 3 2. Unlock the upper handle locks and rotate the upper handle upward and lock it into a position that iscomfortable to you (Figure 4). Figure 4 1....

Installing the Fuse (Model447E Only) Your mower comes with a 40-amp fuse that protects theelectric starter. Important: You cannot start the mower with the electric starter or charge the battery unless youinstall the fuse. 1. Remove the battery cover and the battery and locate the fuse holder (Figure...

Product Overview G008078 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Figure 9 Model 447E shown 1. Lower handle lock 9. Oil fill/Dipstick (not shown) 2. Grass bag 10. Fuel tank cap 3. Upper handle lock 11. Cutting height lever (2) 4. Recoil start handle 12. Spark plug 5. Upper handle (Models446E and 447E onl...

detergent oil with an API service classification ofSF, SG, SH, SJ, SL, or higher.) 3. Install the dipstick. Adjusting the Cutting Height Adjusting the cutting height may bring you intocontact with the moving blade, causing seriousinjury. • Stop the engine and wait for all moving partsto stop. • Do n...

Figure 15 4. If the mower does not start in 1 or 2 pulls (or within 5 seconds using the electric starter), press theprimer button 1 or 2 times and try starting it again. Note: If the mower still does not start, contact an Authorized Service Dealer. Using the Self-propel Drive(Models 446E and 447E On...

To bag the grass clippings, install the grass bag(refer to Installing the Grass Bag) and move theRecycling/bagging lever to the bagging mode (Figure 18). Installing the Grass Bag Raise and hold up the rear door, install the bag, andlower the rear door (Figure 19). G008083 Figure 19 Removing the Gras...

Wet grass or leaves can cause serious injury ifyou slip and contact the blade. Mow only in dryconditions. • Alternate the mowing direction. This helps dispersethe clippings over the lawn for even fertilization. • If the finished lawn appearance is unsatisfactory, tryone or more of the following: – R...

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the first 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level.• Ensure that the engine stops within 3 seconds after releasing the blade control bar.• Clean the ...

Lubrication Lubricating the Wheel Gears Service Interval: Yearly—Lubricate the wheel gears. 1. Remove the wheel bolts on the rear wheels and remove the rear wheels. 2. Apply a lubricating oil to the gear as shown in Figure 22. Figure 22 3. Install the rear wheels. Engine Maintenance Replacing the Ai...

Drive SystemMaintenance Adjusting the Self-propel Drive If your mower does not self-propel properly, adjust theself-propel drive cable. 1. Loosen the nut on the cable mount (Figure 26). Figure 26 1. Nut on cable mount 2. Pull the upper handle back fully rearward (Figure 27). Figure 27 3. Pull the ca...

Blade Maintenance Replacing the Blade Service Interval: Every 25 hours—Replace the bladeor have it sharpened (more frequentlyif the edge dulls quickly). Important: You will need a torque wrench to install the blade properly . If you do not have a torque wrench or are uncomfortable performing thispro...

Cleaning Cleaning the Mower Service Interval: Before each use or daily—Clean the mower. Tipping the mower may cause the fuel to leakfrom the carburetor or the fuel tank. Petrolis extremely flammable, highly explosive, andunder certain condition can cause personalinjury or property damage. Run the en...

CUS TOME R INFO RMATION Date of Sale:-Your Local Dealer:- HAYTER L IMITED, SPELLBROOK, BISHOP’S STORTFORD, HERTS. CM23 4BU, ENGLAND Code Serial No.