Grizzly Industrial Model H8222 - Manuals

Page 2 - Safety Instructions For Spray Guns; For Your Own Safety Read Instruction Manual; SAFETY; NOTICE

Model H8222 Spray Gun -1 - Safety Instructions For Spray Guns 1. READ THIS MANUAL. This gun may cause personal injury if used incor-rectly. This manual contains proper safety and operating instructions that must be followed to reduce this risk. 2. WEAR EYE PROTECTION. Material sprayed into eyes may ...

Page 4 - INTRODUCTION; Foreword

Model H8222 Spray Gun -3 - INTRODUCTION The specifications, details, and photographs in this manual represent the Model H8222 as supplied when the manual was prepared. However, owing to Grizzly’s policy of continuous improvement, changes may be made at any time with no obligation on the part of Griz...

Page 5 - SETUP; Inventory; Setup

Model H8222 Spray Gun -4 - 2. Attach the air hose directly to the air fitting on the spray gun or with a female 1 ⁄ 4 " NPT quick connect fitting (not included). 3. Attach the spray gun to a filtered, regu- lated air source. See the Specifications on Page 3 for your spray gun air pres- sure requ...

Page 6 - Controls

Model H8222 Spray Gun -5 - 1. Fluid Control: Controls the volume of material that travels through the fluid tip. 2. Pattern Control: Adjusts the spray pattern from a round pattern to a wide fan. 3. Atomizing Cap: Controls the spray pattern from vertical to horizontal. 4. Trigger: Squeeze the trigger...

Page 7 - OPERATIONS; Spraying

Model H8222 Spray Gun -6 - OPERATIONS The Model H8222 siphon feed spray gun set is designed to spray a wide variety of materials such as lacquers, stains, prim-ers, multi-component paints, clear coats, acrylics, epoxies etc. It is ideal for auto body and woodworking projects. To use your spray gun: ...

Page 9 - Atomizing Cap and

Model H8222 Spray Gun -8 - Figure 9. Fan adjustment. Rotating the pattern adjustment knob (see Figure 3 ) changes the shape of the spray pattern from a wide spray to a narrow spray, as shown in Figure 9 . The atomizing cap can be adjusted for horizontal or vertical spraying patterns. Spraying in the...

Page 10 - ACCESSORIES

Model H8222 Spray Gun -9 - Figure 10. G6261 Campbell Hausfeld™ water filter. G6261— Campbell Hausfeld™ Water Filter Filtering out water and oil before it reaches the spray gun is critical for high quality spraying results. This filter is rated at 150 PSI maximum air pressure, and has a 1 ⁄ 4 " N...

Page 11 - MAINTENANCE

Model H8222 Spray Gun -10 - MAINTENANCE Cleaning Proper cleaning is the best way to ensure trouble free performance from your spray gun. If your gun is not thoroughly cleaned, damage and poor spraying will result. Problems caused by improper cleaning will not be covered by the warranty. Clean the sp...

Page 12 - Lubrication

Model H8222 Spray Gun -11 - Lubrication Lubricate the following areas with a non-silicon spray gun lubricant after cleaning. A. Atomizing Cap Threads B. Air Valve Packing C. Trigger Pin D. Pattern Control E. Fluid Control Knob F. Air Flow Control Knob Allow the lubricant to coat threads, and run int...