Graco 24C728 B - Manuals - manualsarea.com

Page 2 - Warnings; WARNING

Warnings 2 313643G Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. When these symbols appear in the body of this manual...

Page 4 - Installation; Grounding

Installation 4 313643G Installation NOTE: Reference numbers and letters in parentheses in the text refer to the callouts in the figures and in the parts drawing. Grounding The equipment must be grounded. Grounding reduces the risk of static and electric shock by providing an escape wire for the elec...

Page 5 - Install the Agitator; Angled Adaptor

Installation 313643G 5 Install the Agitator 1. Due to variability in drum heights the lowest set of blades may contact the bottom of the drum. If the bung adapter will not fully seat, or if resistance is felt when installing the agitator, move the blades up the shaft. To move the blades, loosen the ...

Page 6 - Operation; Pressure Relief Procedure; Operate the Agitator; Check Fluid Viscosity; Maintenance; Lubricate the Air Motor

Operation 6 313643G Operation Pressure Relief Procedure 1. Turn off the air regulator and close main air shutoff valve. 2. Disconnect the air line from the motor air inlet. Operate the Agitator 1. Fill the fluid supply container. 2. Start the agitator and run it slowly. 3. Use the needle valve (11) ...

Page 7 - Repair; Flush the Air Motor; Air Motor

Repair 313643G 7 Repair Flush the Air Motor If the motor is sluggish or inefficient, flush it with non-flammable solvent in a well-ventilated area. 1. Follow the Pressure Relief Procedure. Seepage 6. 2. Add several teaspoons of solvent, or spray the sol-vent directly into the motor. 3. Rotate the sh...

Page 8 - Parts

Parts 8 313643G Parts 1 Torque to 65 in-lb (7.3 N•m) 1 1 2 3 4 7 6 8 8 9 11 12 13 15 Torque to 80 in-lb (9 N•m) 2 2 ti14649a 1 7 16

Page 9 - Dimensions

Parts 313643G 9 Part No/Description * Air Motor Repair Kits may be purchased separately. Order Kit 207335 for Model 24C728 (low viscosity) or Kit 224954 for Model 24C729 (high viscosity). Dimensions 2 in. Bung Adapter 1-1/2 in. Bung Adapter Ref. No. Part No. Description Qty. 1* 16A871111310 MOTOR, a...

Page 10 - Technical Data

Technical Data 10 313643G Technical Data * Tested in water to ISO 9614-2. Maximum working pressure 100 psi (0.70 MPa, 7.0 bar) Maximum recommended agitator speed . . . . . . . . . . . . . 500 rpmAir consumption at 400 rpm with 100 psi (0.7 MPa, 7 bar) air inlet pressure Model 24C728 (low viscosity) ...

Page 12 - Graco Standard Warranty

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 313643 Graco Headquarters: Minneapolis Int...