Edelbrock 1615 - Manuals

Edelbrock 1615 – Manual in PDF format online.

Manuals:

Manual Edelbrock 1615

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6

Summary

Page 3 - ©2006 Edelbrock Corporation; Remove lower rocker boxes as an assembly then; Cylinder head gasket

©2006 Edelbrock Corporation Brochure #63-1602 Page 3 of 6 Catalog #1602, 1615Rev. 4/06 - RS/mc REMOVE ROCKER ARM COVERS 1. Remove bolts (1) and seals (2) (See Figure 1) . Use a shortened 3/16" allen wrench. 2. Remove top (3) and middle (4) sections of rocker box. Removegaskets (5, 6, and 7) and ...

Page 4 - Be sure the gasket surfaces and stud holes are clean and dry; Front cylinder

©2006 Edelbrock Corporation Brochure #63-1602 Page 4 of 6 Catalog #1602, 1615Rev. 4/06 - RS/mc CYLINDER HEAD INSTALLATION CAUTION Install new O-rings over the cylinder dowels beforeinstalling the head gasket. Install the O-rings first toensure alignment of the head gasket and preventgasket leaks. CA...

Page 6 - CAUTION; If the original push rods are being installed, be sure; Edelbrock Corporation • 2700 California St. • Torrance, CA 90503; Figure 11 - Rocker Arm Shaft Bolt Notches

©2006 Edelbrock Corporation Brochure #63-1602 Page 6 of 6 Catalog #1602, 1615Rev. 4/06 - RS/mc CAUTION Do not turn engine over until push rods spin freely.Damage could occur to valves. NOTE: If the original push rods are being installed, be sure you do not turn them end for end from their original p...

Edelbrock Manuals