Page 2 - TYPICAL FRONT-LOAD DIN MOUNTING METHOD; INSTALLATION; Preparation
2 TYPICAL FRONT-LOAD DIN MOUNTING METHOD Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions.• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, o...
Page 3 - FUSE; Wiring Diagram
3 FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XML8150 uses one10 amp ATM fuse located beside the wiring connector. XML8150 INSTALLATION Wiring Diagram Antenna Connector Steering Wheel Interface Input (PAC SW...
Page 4 - OPERATION; Control Locations - Receiver
4 XML8150 OPERATION Control Locations - Receiver Front Panel Release Select / Power ( ) Talk Tune / Track Down Tune / Track Up End Call Audio / Menu Auxiliary Input USB Port Preset 6 / Folder Up 123 456 Preset 5 / Folder Down Preset 4 / Play / Pause Preset 3 / Intro Preset 2 / Random Preset 1 / Re...
Page 5 - Control Locations - Remote
5 XML8150 OPERATION Control Locations - Remote Key 9 Mute / End Call Key 0 / Display Talk Key 8 / Tag Key 7 Preset 4 / Play / Pause Preset 1 / Repeat Band / ESC / Key * Tune / Track Down 1 23456 7 8 9 10 12131415161718 1920 Mode Select / Power ( ) Volume Up Audio / Menu Tune / Track Up Volume Down ...
Page 6 - General Operation; nn
6 XML8150 OPERATION Power On/Off Mode Steering Wheel Interface Input Auxiliary Input Volume Mute Reset Display Set the Clock 12/24-Hour Clock Setup Menu General Operation Press or any other button to turn unit on. Press and hold to turn unit off. Press MODE to select between AM/FM, auxiliary inp...
Page 8 - Audio Menu
8 XML8150 OPERATION Press AUDIO/MENU until BASS appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Press AUDIO/MENU until MIDDLE appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Press AUDIO/MENU until TREBLE appears, then rotate ...
Page 9 - Audio Menu - Advanced Control
9 Bass Center Frequency Middle Center Frequency Treble Center Frequency Bass "Q" Factor Mid "Q" Factor Low Pass Filters Press AUDIO/MENU until BASS appears. Then press SELECT until BAS FREQ appears. Rotate the volume knob to adjust (60Hz - 80Hz - 100Hz - 200Hz). Press AUDIO/MENU unti...
Page 10 - AM/FM Tuner Operation
10 XML8150 OPERATION Display Seek Tuning Manual Tuning Scan Tuning Band Storing and Recalling Station Presets When using the XML8150 without the optional HDM90, press DISP to toggle the display between the following options: Press TUNE nn or TUNE ll for more than one second to seek the next stro...
Page 11 - ll; HD RadioTM AM/FM Tuner Operation
11 XML8150 OPERATION Connecting the HDM90 (sold separately) Display HD Radio Tuning HD Seek Mode Auto Station Store Setting HD Radio Presets Recalling an HD Radio Multicast Preset HD Radio operation requires connecting the HDM90 HD Radio tuner (sold separately). Refer to the HDM90 instructions fo...
Page 12 - iTunes
12 XML8150 OPERATION The iTunes Tagging feature of the XML8150 requires the optional HDM90 module (sold separately). Once connected, the HDM90 allows the user to "Tag" songs that are playing on HD Radio™ stations and enables them to be purchased later through iTunes. With the touch of a but...
Page 13 - Troubleshooting
13 XML8150 OPERATION iTunes ® Tagging Operation (HDM90) Device Compatibility with iTunes Tagging Compatible with • *iPhone 4 • *iPhone 3GS • *iPhone 3G • *iPhone • iPod nano (5th generation) • *iPod touch (2nd generation) • iPod nano (4th generation) • iPod classic • *iPod touch (1st generation) •...
Page 14 - RELEASE; Dock for iPod - Removing the Dock
14 Press the RELEASE button on the top left corner of the front panel. Fold down front panel. The dock is located behind the panel. Using handle on the dock, pull dock out and towards the right side of the unit. Rotate dock 90 degrees counterclockwise to the vertical position. Fold up and close the ...
Page 15 - Dock for iPod - Docking a Device; PUSH
15 Dock for iPod - Docking a Device To dock an iPod/iPhone device, squeeze the side PUSH buttons and raise the top support of the dock to provide clearance for the device. Line up the dock connector on the iPod/iPhone device with the connector located on the bottom of the dock. Lower the top support...
Page 16 - Connecting an iPod/iPhone Device
16 XML8150 OPERATION Connecting an iPod/iPhone Device Operation of iPod/iPhone - Full Control Remove the dock from the XML8150 and dock an iPod or iPhone device as shown on pages 14-15. When a device is docked, playback will begin automatically. To play music from an iPod/iPhone device using the di...
Page 17 - Music Search Menu
17 XML8150 OPERATION Operation of iPod/iPhone - Full Control Search Category Menu Navigation Playlist Menu Playlists Songs Artist Menu Artists Albums Songs Album Menu Albums Songs Song Menu Songs Audiobook Menu Audiobooks Podcast Menu Podcasts Genre Menu Genre Genres List Artists Albums Songs See t...
Page 18 - Operation of iPod/iPhone - Manual Control; Device Compatibility
18 XML8150 OPERATION Operation of iPod/iPhone - Manual Control When the control of iPod/iPhone feature is set to "MANUAL" in the setup menu, use the following functions to control the device: When "MANUAL" control is selected from the setup menu, the iPod or iPhone device can be co...
Page 19 - USB/SD Card Operation; File and Folder Search
19 XML8150 OPERATION To play MP3/WMA/AAC files from most mass storage devices,connect a device to the XML8150's USB port. To play MP3/WMA/AAC files from an SD Card, insert an SD card into the XML8150's SD card slot, located behind the front panel. Insert the SD card with the label facing to the lef...
Page 20 - USB / SD Card Operation
20 XML8150 OPERATION When a file is accessed, the clock and elapsed time will be displayed. Press DISP momentarily to select file name (default), song title, artist, track number or clock & elapsed time. • "NO TITLE" will be displayed if no song title information is available. • "NO...
Page 23 - Bluetooth; Pairing a Device
23 XML8150 OPERATION Bluetooth ® Operation Most Bluetooth devices support the auto-connect feature, and will connect automatically if the device is in range when the XML8150 is powered-on. If your device was previously paired but does not connect, use these instructions below. • If your most recen...
Page 24 - Making a Phone Call
24 XML8150 OPERATION Bluetooth ® Operation Making a Phone Call • Press once. "ENTER NUM" will be shown, then an "_" will appear on the display. • Using the remote control, enter the phone number using the 0-9 buttons. Press on the remote control or XML8150 front panel to begin dial...
Page 25 - During a Phone Call
25 XML8150 OPERATION Bluetooth ® Operation During a Phone Call Turn the volume knob to adjust the volume level during a phone call. Bluetooth mode has a separate volume level from the main volume of other modes. The XML8150 will remember the volume level in Bluetooth mode and always return to the ...
Page 26 - Streaming Audio Operation
26 XML8150 OPERATION Bluetooth ® Operation The XML8150 supports A2DP (advanced audio distribution profile) wireless streaming audio from your Bluetooth mobile device directly to your head unit. You can also control your music from the front panel of the head unit using AVRCP (audio video remote co...
Page 27 - Bluetooth Setup Menu
27 XML8150 OPERATION Bluetooth ® Operation Menu Function Options Action Bluetooth Mode BL'TOOTH ON Enables the Bluetooth feature. The Bluetooth icon will flash occasionally when not paired and connected to a mobile device. BL'TOOTH OFF Disables the Bluetooth feature. Auto Connect AUTO CON ON Allo...
Page 28 - Limited One Year Warranty
28 XML8150 OPERATION This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the...
Page 29 - Troubleshooting - General
29 XML8150 OPERATION Problem Cause Action Unit will not turn on (no power) Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has...
Page 30 - Specifications
30 XML8150 OPERATION Specifications Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz Speaker output impedance...
Page 31 - FCC Compliance
31 FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warnin...