Page 2 - Preparation; TYPICAL MOUNTING METHOD; INSTALLATION
2 Preparation KEYS HEX BOLT MOUNTING SLEEVE PLAIN WASHER HEX NUT MOUNTING STRAP TYPICAL MOUNTING METHOD MXD25 INSTALLATION Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions.• Avoid installing the un...
Page 3 - Wiring Diagram
3 Rear Preamp Output Connect to amplifier RCA input Antenna Connector RCA Cable (sold separately) AMP BLUE BLACK RED YELLOW Remote Turn-On Connect to amplifier or powerantenna. Insulate wire if not used. Ground Connect to chassis ground. Accessory Connect to ignition circuit or switched 12 volt sour...
Page 4 - Control Locations; OPERATION
4 Control Locations Release Mode Power Rotary Encoder Preset 4/Play/Pause Preset 1/Repeat Preset 5 Preset 2/Random Preset 3/Intro Preset 6 123456789 10 Tune/Track Down Eject Tune/Track Up EQ/Stereo/Mono Auxiliary Input Audio/Loudness USB Charge AS/PS Band Display 111213141516171819 17 16 1 2 3 8 19 ...
Page 5 - General Operation; nn
5 General Operation Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate. Press PWR to turn ...
Page 7 - Tuner Operation; ll
7 Tuner Operation Press TUNE nn or TUNE ll momentarily to seek the next strong station. Press TUNE nn or TUNE ll for more than 2 seconds, then release. “MANU” will momentarily appear in the display. Press TUNE nn or TUNE ll momentarily to move radio frequency up or down one step at a time. Press and...
Page 8 - CD Player Operation
8 CD Player Operation With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. Press TRACK ll to skip to the beginning of the next track. Press TRACK nn to retu...
Page 9 - Troubleshooting; Error Codes
9 Troubleshooting Problem Cause Action Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections ...
Page 10 - Limited One Year Warranty; WARRANTY
10 Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date...
Page 11 - NOTES
Page 12 - Specifications; CEA-2006 Power Standard Specifications
Specifications Frequency response: 20Hz-20kHzChannel separation @ 1kHz: >65dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 12dBf 50dB quieting sensitivity: 16dBfStereo separation @ 1kHz: 40dBFrequency response: 30Hz-13kHz Tuning range: 530kHz-1710kHz Usable sensitivity:...