Dixon 700 Series - Manuals

7. DO NOT MOVE STEERING CONTROL LEVERS from forward position to reverse position rapidly. The speed and/or direction of travel is affected instantly by movement of the Steering Control Levers. 8. DO NOT ALLOW CHILDREN TO OPERATE MOWER. Do not allow others who have not had instruction to operate mowe...

25. MOW ONLY DURING DAYLIGHT. 26. THIS MACHINE IS NOT MEANT FOR HIGHWAY OR STREET USE. It is not a recreational vehicle and it should not be operated as such. 27. ALWAYS DISENGAGE THE MOWER BLADE CLUTCH when transporting. SAFETY INTERLOCK SYSTEM Your Zero Turning Radius Mower is equipped with switch...

12. Clean the air intake screen on the engine if necessary. 13. Perform any other maintenance as it becomes necessary. (See the "Maintenance" section of this manual.) IMPORTANT: Before cutting grass, clutch must be broken-in as follows: With engine at full RPM engage deck until blades come t...

MOWING RECOMMENDATIONS 1. Keep mower blades sharp. 2. Make sure deck and discharge are clean. 3. When mowing tall grass, make two passes, mowing off 1/2 of the desired cut on the first pass, and then the desired height the second pass. Check for hidden dangers first. 4. Go slowly for trimming. 5. Al...

MAINTENANCE INSTRUCTIONS 1. ENGINE: For complete maintenance and operating information for your engine, please refer to your engine operating and maintenance instructions furnished by the engine manufacturer and included in your Dixon Zero Turning Radius Mower information packet. NOTE: Air intake sc...

8. STEERING CONTROL ADJUSTMENTS A. To Adjust Neutral: a. Remove the fender skirts from each side of the machine. b. Block up the unit so that the Drive Wheels are off the ground. c. Start the engine and run at a fast idle with the Steering control levers in the "out" position. d. Loosen the ...

PROCEDURE FOR RAISING AND LOWERING THE DECK FOR SERVICING 12. RAISING THE DECK: A. Remove cut height adjustment pin and completely lower the cut height adjustment lever. Re-insert the cut height adjustment pin into the 3-1/2° cut height position (this will lock the cut height adjustment lever into t...

- . . . . . ' TROUBLE SHOOTING CHECK LIST 1. ENGINE WONT TURN OVER: Mower blades engaged ——---------————————————————— disengage blades Drive not in neutral ----------— move Steering Control Levers to neutral "OUT" position Blown fuse ———————————--------————————————————— replace fuse Dead bat...

WARNING The Engine Exhaust from this product contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. ®Dixon and ZTR are registered trademarks of Dixon Industries, Inc. Dixon Industries, inc. A BLOUNT International, Inc. company P.O. Box 1569 Cof...