Directed Electronics Car Alarm - Manuals

4 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d ttrra an nssm miitttte err ffu un nc cttiio on nss The system uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any trans- mitter button to any system function. ...

5 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d u ussiin ng g yyo ou urr ssyysstte em m The buttons used in the instructions in this manual correspond to the standard configuration. Remember, this is not the only way your transmitter may be set up. It can be cus...

6 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d as it does when the system is armed. The siren will chirp one time 20 seconds after the last door has been closed. The system is not actually armed at that point. The system arms and the doors lock (if connected an...

7 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d ➤ Turning on the ignition key will trip the same two-stage response as opening a door. ➤ The optional starter kill prevents the vehicle’s starter from cranking. multi-level security arming (optional feature) Multi-...

8 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d ➤ ➤ Pressing the arm button a fourth time within five seconds: The siren chirps four times followed by a long chirp. Zones Two and Four are now bypassed. ➤ ➤ Pressing the arm button a fifth time within five seconds...

9 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d disarming To disarm the system, press . You will hear two chirps, and the parking lights will flash twice. If the power locks are connected to the system, the doors will unlock. If the siren chirps either four or f...

10 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d the vehicle’s ignition key and know where the Valet button is located. Be sure to check with the installer for the location and the number of presses of the Valet button required to disarm the system. To disarm th...

12 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet switch...

13 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d ignores, or bypasses, that sensor (along with any other sensors sharing the same zone) for 60 minutes. If the bypassed sensor tries to trigger the system while it is being bypassed, the 60-minute bypass period wil...

14 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d during your absence. Refer to the System Status Chirps and Table of Zones charts for diagnostic information. arming diagnostics If the system is armed while an input is active (door open, sensor triggering, etc.) ...

15 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d was involved (see Table of Zones section). The system will retain this information in its memory, and continue to chirp four or five times each time it is disarmed, until the next time the igni- tion key is turned...

16 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below, along with spaces to write in any optional sensors or switche...

17 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d a an nttii--c co od de e g grra ab bb biin ng g The receiver and transmitters each use mathematical formulas called algorithms to change their codes each time the transmitter is used. This technology has been deve...

18 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d h hiig gh h ffrre eq qu ue en nc cyy Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range – even in ...

22 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d system with the transmitter. It is also possible to disarm the AED feature by turning the ignition key to the RUN posi- tion and pressing the Valet button the programmed number of times. AED is disabled when the s...

24 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d vve eh hiic clle e rre ec co ovve erryy ssyysstte em m ((vvrrss ® ® )) The optional VRS ® feature is designed to ensure that any unau- thorized user of your vehicle (even if using your keys and remote control) wil...

25 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d arming the vrs ® To arm the VRS ® , turn the ignition to the ON position and press the arm button on the remote transmitter for one second. The parking lights will flash and the siren will chirp once. This can be ...

26 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d Fifteen seconds after the siren chirps begin, the siren’s output will change to a continuous blast. From this point on, when the ignition key is turned off, the VRS ® will immediately turn on the starter kill. Thi...

27 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d twice. If the system has entered the triggered sequence (siren has begun chirping), pressing the disarm button of the transmitter will not disarm VRS ® . To disarm the VRS ® during a VRS ® trigger sequence: 1. Tur...

28 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d g gllo ossssa arryy o off tte errm mss Control Unit: The "brain" of your system. Usually hidden under the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all...

29 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d alarm is triggered. Transmitter : Hand-held, remote control which operates the various functions of your system. Trigger or Triggered Sequence : This is what happens when the alarm "goes off " or "trip...

30 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d sse ec cu urriittyy & & c co on nvve en niie en nc ce e e exxp pa an nssiio on nss Here we have listed only some of the many expansion options available. Please contact your dealer for a complete explanati...

31 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d Power Trunk Release: The channel two output of the system can operate a factory power release for the vehicle’s trunk or hatch. (An additional relay may be required.) If the factory release is not power activated,...

Vista, CA 92083 www.directed.com © 2005 Directed Electronics - All rights reserved G909429 07-05 The company behind this system is Directed Electronics. Since its inception, Directed ® has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories ...