Dimplex WRCPF-KIT - Manuals

Page 2 - Table of Contents; the user to the risk of fire,

2 www.dimplex.com Table of Contents ! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, w...

Page 3 - Welcome & Congratulations; Thank you and congratulations for choosing to purchase a Wall; Please carefully read and save these instructions.; Read all instructions and warnings carefully before; NO NEED TO RETURN TO THE STORE; Questions with operation or assembly? Require Parts Information?; OR

3 Welcome & Congratulations Thank you and congratulations for choosing to purchase a Wall Switch Remote Control Kit from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting inst...

Page 4 - Product Overview; The Wall Switch Remote Control

4 www.dimplex.com Product Overview The Wall Switch Remote Control Kit is designed to work with the following Dimplex electric fireplaces: BF33STP • BF33DXP • BF39STP • BF39DXP • BF45DXP • BFSL33 • BLF50 • DF3033ST • DFG3033BLK • For the BF units, mentioned above, follow the Remote Receiver control i...

Page 7 - Wall Control Installation; use a qualified and licensed; Site Selection for; all wiring or consult a qualified; Installation; Required Tools and Hardware:

7 Wall Control Installation ! NOTE: All electrical wiring must comply with all national and local electrical codes and regulations. Always use a qualified and licensed electrician should you have any questions or concerns for all wiring work. ! NOTE: The Wall Switch Remote Control is made to fit sta...

Page 8 - Figure 5; Figure 6

8 www.dimplex.com Figure 5 Outer Housing Controller 2. Release the Controller from its Outer Housing by pushing the front face into the Outer Housing until you hear a click. This will release the push- lock latches and allow the Controller to be removed from the Outer Housing (Figure 5). 4. Replace ...

Page 9 - Hard Wired Power Supplied; Figure 8

9 Wall Control Installation to complete the installation and to blend the installation in with your choice of decor. Hard Wired Power Supplied Installation Before starting this installation, it is helpful to initialize the Wall Switch Remote Control with your firebox (see Initialization section). Yo...

Page 11 - Locking Screw Option; without being removed first from

11 Wall Control Installation Figure 12 Controller Outer Housing Figure 13 Locking Screw Option (Figure 14) To prevent tampering, damage, and theft, it is suggested to install the locking screws. Once installed, the locking screws will prevent the Controller from being released from the Outer Housing...

Page 13 - supplied flat head screws.

13 ! NOTE: Wire leads are not polarized due to the nature of this device. 9. Coil excess wiring to the back of the device box and insert the Controller and Outer Housing into the device box (Figure 16). Fasten with two supplied flat head screws. 10. Attach your choice of Decora style faceplate (not ...

Page 14 - Initialization; specific model of fireplace and; BF Models Using the Included; turn Main; REMOTE; will then flash for 10 seconds.

14 www.dimplex.com Initialization After installation, locate the section which applies to your specific model of fireplace and follow the steps for remote control initialization and if required, re-initialization. Refer to your fireplace's owner's manual to locate manual or other controls as needed....

Page 15 - the fireplace in the upper right; Remote; initialized with the fireplace.; Operation; Manual Controls; please consult your Owner's

15 Initialization DF3033ST and DFg3033 Models 1. Ensure that power is supplied through main service panel. 2. Ensure the Main On/Off Switch located in the switch box on the fireplace in the upper right hand corner is in the On position (Figure 19A) . A B C Figure 19 DF3033ST / DFG3033 Manual control...

Page 16 - C. Manual Selection Switch

16 www.dimplex.com Operation A. On Button Pressing this button toggles sequentially through the three levels of the fireplace. Pressing once activates Level 1 - flame effect only, twice activates Level 2 - flame effect and Purifire™, three times activates Level 3 - flame effect, Purifire™ and heat. ...

Page 17 - Wall Switch Remote Control

17 Operation Wall Switch Remote Control 1 3 5 2 4 6 7 9 11 8 10 12 13 14 1. Room Temperature 2. Set Temperature 3. Flame Effect 4. Purifire™ 5. Heat Off Indicator 6. Function Lock Indicator 7. RF Code Function Indicator 8. Set Temperature Down 9. Set Temperature Up 10. Flame Off 11. Flame On 12. Pur...

Page 19 - RF Code Function and; procedure as needed to find a; Low Battery Indicator; Other Functions; Hour Sleep Timer; ” will flash until

19 Operation 7. RF Code Function and Change Procedure In the event that the Wall Switch Remote Control does not work properly with the receiver due to interference from additional wireless signals, this function will allow the RF code to be changed.To enable this function, press 9 and 12 together. “...

Page 20 - Warranty

20 www.dimplex.com Warranty This Dimplex Wall Switch Remote Control is warranted against defects in workmanship and materials for two years from date of sale. This warranty does not apply to damage from accident, misuse, or alteration, nor where the connected voltage is more that 5 % above the namep...