Delta TP400LS - Manuals

5 A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and matching receptacle which will...

6 EXTENSION CORDS Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grounding type plug and matching receptacle which will accept the machine’splug. When using an extension cord, be sure to use one heavy enough to carry ...

7 FOREWORD FUNCTIONAL DESCRIPTION UNPACKING AND CLEANING Carefully unpack the machine and all loose items from the shipping container. Peel protective film from the table surface.Figures 1 and 2 illustrate the planer and all loose items supplied with your machine. Refer to the section of this manual...

10 FASTENING PLANER TO STAND 2. Fasten cutterhead raising and lowering handle (A) Fig. 8, to shaft using the M5x.8x20mm hex socket headscrew (C) with wrench supplied. 3. Rotate handle (A) to the operating position as shown in Fig. 9, and tighten set screw (D). Place the planer on the stand and align...

11 STARTING ANDSTOPPING PLANER The on/off switch (A) Fig. 14, is located on the front ofthe planer motor. To turn the machine “ON” move the switch up to the “ON” position. To turn the machine “OFF” move the switch down to the “OFF” position. LOCKING SWITCH INTHE “OFF” POSITION When the tool is not i...

13 KNIFE TRANSFER TOOLSTORAGE 1. The knife transfer tool (A) Fig. 20, supplied with your planer, can easily be stored underneath the outfeedtable extension (B) when not being used. A Velcro strip(C) is provided on the tool and underneath the table forthis purpose. 2. Figure 21 illustrates the knife ...

14 Fig. 22 Fig. 23 CARRYING HANDLE/STOCK TRANSFER BAR 1. Your planer is provided with a foam covered carrying handle (A) Fig. 22, located on top of the machine, for ease in transporting the planer. Carrying handles are also provided at the base of the planer on each side which allow you to lift the ...

17 Fig. 34 Fig. 35 2. Make sure the knives are inserted into the cutterhead properly, as explained under “REPLACING KNIVES.” 3. Place the gage block (A) Fig. 34, on the table, over a 0.020" feeler gage and position the gage block (A) directlyunderneath the cutterhead. Raise or lower the headasse...

18 MAINTENANCE BRUSH INSPECTIONAND REPLACEMENT DISCONNECT MACHINE FROM POWER SOURCE. Brush life varies. It depends on the load on the motor.Check the brushes after the first 50 hours of use for anew machine or after a new set of brushes has beeninstalled. After the first check, examine them after ab...

20 A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers, and Delta Authorized Service Stations. Please visit our Web Site www.deltamachinery.com for a catalog or for the name of your nearest supplier. Since accessories other than those of...

The following are trademarks of PORTER-CABLE • DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marques suivantes sont des marques de fabriquant de la PORTER-CABLE • DELTA): Auto-Set ® , BAMMER ® , B.O.S.S. ® , Builder’s Saw ® , Contractor’s Saw ® , Contractor’s Saw II...