Delta LCP-10G3A4EDR - Manuals

Page 2 - Shall be pulled low to

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 2 Revision: 0B 2008/9/5 www.deltaww.com Absolute Maximum Ratings Parameter Symbol Min. Typ. Max. Unit Storage Temperature T S -40 85 ºC Supply Voltage Range @3.3V V CC3 -0.5 3.6 V Recommended Operating Conditions Parameter Symbol Min. Typ. Max. Unit Case Operati...

Page 3 - Optical Transmitter Characteristics (T; Transmitter eye mask definition

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 3 Revision: 0B 2008/9/5 www.deltaww.com Optical Transmitter Characteristics (T C = -5 to 70 ) ℃ ℃ Parameter Symbol Min. Typ. Max. Unit Note Data Rate R 10.3125 Gb/s Signaling speed variation from nominal. ±100 ppm Average Output Power P avg -5 -1.8 dBm Wavelengt...

Page 4 - Optical Receiver Characteristics (T

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 4 Revision: 0B 2008/9/5 www.deltaww.com Optical Receiver Characteristics (T c = -5 to 70 ) ℃ ℃ Parameter Symbol Min. Typ. Max. Unit Note Signaling speed (nominal) T S 10.3125 Gb/s Signaling speed variation from nominal. ±100 ppm Center Wavelength λ 840 860 nm Ov...

Page 5 - Link Length; Fiber type; SFP+ Transceiver Electrical Pad Layout

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 5 Revision: 0B 2008/9/5 www.deltaww.com Link Length Fiber type Minimum modal bandwidth @ 850nm (MHz*km) Operating range (meters) Note 160 2 to 26 4 62.5 um MMF 200 2 to 33 4 400 2 to 66 4 500 2 to 82 4 50 um MMF 2000 2 to 300 4 SFP+ Transceiver Electrical Pad La...

Page 6 - Module Electrical Pin Definition; Pin

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 6 Revision: 0B 2008/9/5 www.deltaww.com Module Electrical Pin Definition Pin Logic Symbol Name/Description Note 1 VeeT Module Transmitter Ground 1 2 LVTTL-O TX_Fault Module Transmitter Fault 2 3 LVTTL-I TX_Disable Transmitter Disable; Turns off transmitter laser...

Page 7 - Low speed electrical control pins and 2-wire interface; resistor in the

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 7 Revision: 0B 2008/9/5 www.deltaww.com Low speed electrical control pins and 2-wire interface In addition to the 2-wire serial interface, the SFP+ module has the following low speed pins for control and status: ‧ TX_Fault ‧ TX_Disable ‧ RS0/RS1 ‧ MOD_ABS ‧ RX_L...

Page 9 - Recommend Circuit Schematic

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 9 Revision: 0B 2008/9/5 www.deltaww.com Recommend Circuit Schematic

Page 10 - Package Outline Drawing for Metal Housing with Bail de-latch; Latch Color Identifier; Black

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 10 Revision: 0B 2008/9/5 www.deltaww.com Package Outline Drawing for Metal Housing with Bail de-latch Latch Color Identifier Black Co mp lie s w ith 2 1 CFR 1040 .10 and 10 40. 11 Ma de in x FSFS

Page 11 - Timing parameters for SFP+ management; Parameter

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 11 Revision: 0B 2008/9/5 www.deltaww.com Timing parameters for SFP+ management Parameter Symbol Min. Max. Unit Note TX_DISABLE Assert time t_off 10 µ sec 1 TX_DISABLE Negate time t_on 2 msec 2 Time to initialize 2-wire interfase t_2w_start_up 300 msec 3 Time to ...

Page 12 - Enhanced Digital Diagnostic Interface; Digital Diagnostic Memory Map Specific Data Field Descriptions

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 12 Revision: 0B 2008/9/5 www.deltaww.com Enhanced Digital Diagnostic Interface The memory map in the following describes an extension to the memory map defined in SFP MSA. The enhanced interface uses the two wire serial bus address 1010001X(A2h) to provide diagn...

Page 14 - Digital Diagnostic Monitoring Interface; Address

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 14 Revision: 0B 2008/9/5 www.deltaww.com Digital Diagnostic Monitoring Interface Alarm and Warning Thresholds (2-Wire Address A2h) Address # Bytes Name Value (Dec.) Unit Note 00-01 2 Temp High Alarm 85 degree Celsius 02-03 2 Temp Low Alarm -10 degree Celsius 04-...

Page 15 - Optional Set of Alarm and Warning; Digital Diagnostic Monitor Accuracy

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 15 Revision: 0B 2008/9/5 www.deltaww.com 6) State/ Control Bits Byte Bit Name Description 110 7 Tx Disable State Digital state of the Tx disable input pin 110 6 Soft Tx Disable Read/ Write bit that allow software disable of laser 110 5 Reserved 110 4 Rate Select...

Page 16 - Regulatory Compliance; Feature; Contact Discharge

LCP-10G3A4EDR DELTA ELECTRONICS, INC. 16 Revision: 0B 2008/9/5 www.deltaww.com Regulatory Compliance Feature Test Method Reference Performance Electromagnetic Interference (EMI) FCC Part15 Class B EN 55022 Class B (CISPR 22A) Radio Frequency Electromagnetic Field Immunity IEC/EN 61000-4-3 Contact Di...