Delta DTH3635 - Manuals - manualsarea.com

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; CONSUMER SAFETY INFORMATION

2- ENG A00543 IMPORTANT SAFETY INSTRUCTIONS Do not operate this unit until you have read and understand this Operators Manual and the Engine Owners Manual for Safety, Operation, and Maintenance Instructions. RISK OF EXPLOSION OR FIRE HAZARD WHAT CAN HAPPEN HOW TO PREVENT IT • Spilled gasoline and it...

Page 6 - ASSEMBLY INSTRUCTIONS; The high pressure pump was; CARTON CONTENTS; There will be a slight amount of

6- ENG A00543 ASSEMBLY INSTRUCTIONS NOTE: The high pressure pump was filled with oil at the factory. There is noneed to add oil at this time, see theMaintenance section of this manualfor Maintenance information. 5. Connect wand to gun. Tightensecurely. 4. Attach highpressure hose togun. Tighten secu...

Page 7 - OPERATING INSTRUCTIONS; High Pressure Pump; Fuel Valve Lever

7- ENG A00543 OPERATING INSTRUCTIONS BASIC ELEMENTS OF APRESSURE WASHER High Pressure Pump : Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose: Carries the pressurized water from the pump tothe gun and spray wand. Spray Gun: Connects with spray wan...

Page 8 - PRESSURE ADJUSTMENTS; Back away from the surface to; The further away you; Thermal Relief Valve:; Mixes

8- ENG A00543 PRESSURE WASHEROPERATING FEATURES PRESSURE ADJUSTMENTS The pressure setting is preset at thefactory to achieve optimum pressureand cleaning. If you need to lower thepressure, it can be accomplished bythese methods. 1. Back away from the surface to be cleaned. The further away you are, ...

Page 10 - STARTING

Changing Nozzles on Spray Wand DO NOT attempt tochange nozzles while pressure washer is running.Turn engine off before changingnozzles. 1. Pull quick connect coupler back and insert nozzle. 2. Release quick connect couplerand twist nozzle to make sure it issecure in coupler. Risk Of Injury.Ensure no...

Page 11 - SHUTTING DOWN; MAINTENANCE; ENGINE

STARTING (continued) 4. Connect water source to pump inlet. NOTE: Water source must provide a minimum of 5 gallons perminute at 20 PSI. 5. Connect high pressure hose to pump outlet. 6. If applying a chemical orcleaning solution , see How To Apply Chemicals/CleaningSolvents instructions in thissectio...

Page 12 - PUMP; NOZZLE CLEANING

12- ENG A00543 4. Remove the high-pressure nozzlefrom the spray wand. Remove anyobstructions with the nozzlecleaning tool provided andbackflush with clean water. 5. Direct water supply into spraywand to backflush loosenedparticles for 30 seconds. 6. Reassemble the nozzle to thewand. 7. Reconnect spr...

Page 13 - STORAGE; Disconnect spark plug wire.; Windshield washer fluid may also be; PRESSURE WASHER

13- ENG A00543 STORAGE ENGINE Consult the Engine Owners Manual forthe manufacturer's recommendations forstorage. PUMP The manufacturer recommends usinga pump protector/winterizer whenstoring the unit for more than 30 daysand/or when freezing temperatures areexpected. If a pumpprotector/winterizer is...

Page 14 - TROUBLE SHOOTING GUIDE; PROBLEM

14- ENG A00543 TROUBLE SHOOTING GUIDE PROBLEM Engine will notstart (see EngineManual forfurther engine troubleshooting) No or lowpressure (initial use) CAUSE CORRECTION No fuel. Add Fuel. Pressure builds up after two pullson the recoil starter or after initialuse. Squeeze gun trigger to relievepress...

Page 16 - WARRANTY

16- ENG A00543 A00543 A00543 A00543 A00543 WARRANTY DELTA MACHINERY warrants to the original purchaser that all products covered under this warranty are free from defects in material and workmanship. Products covered under this warranty include air compressors, airtools, service parts, pressure wash...