Delta AP200 - Manuals

6 AIR CLEANER PARTS Fig. 2 1 - Air cleaner 2 - Four 5/16-18x1½" eye-bolts 3 - Four 5/16-18 flange nuts 4 - Four rubber feet 1 2 3 4

7 ASSEMBLY INSTRUCTIONS WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTIONMANUAL. The Air Cleaner requires very little assembly; therefore, determine in which position the Air Clean...

OPERATING CONTROLS ON/OFF SWITCH The Air Cleaner is equipped with an in-line rocker switch(M) Fig.11, located on the power cord (N). To start orstop the motor, press downward on the rocker switch. NOTE: The switch has markings on the side to determine the on/off position. We suggest that whenfinishe...

10 Fig. 16 5. Fig. 16, illustrates the air cleaner being used in a floor sanding application. Fig. 17 6. Fig. 17, illustrates the air cleaner suspended from wooden ceiling supports for overhead operation. WARNING: Keep a minimum of seven feet between bottom of air cleaner and the floor surface. When...

Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a Delta factory service c...