Delta 43-424 - Manuals

14 Fig. 38 Fig. 39 Fig. 40 ASSEMBLING SPINDLE GUARD A 4-1/2" diameter spindle guard is supplied as standard equipment and is supplied with a 1/2" bushingwhich enables the guard to be used with both the 1/2" and 3/4" spindles. CAUTION: The diameter of the spindle guard should be at le...

15 CONNECTING SHAPER TO POWER SOURCE GROUNDING INSTRUCTIONS CAUTION: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATORFROM ELECTRIC SHOCK. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electriccurrent to reduce the risk of electric shock....

16 STARTING AND STOPPING THE SHAPER To apply power to the machine, push “ON” button (A) Fig. 43. To stop the machine,push “OFF” button (B). LOCKING SWITCH IN THE “OFF” POSITION IMPORTANT: We suggest that when the shaper is not in use, the switch be locked in the “OFF” position using a padlock (C) Fi...

18 FENCE CONTROLS AND ADJUSTMENTS Fig. 50 Fig. 51 Fig. 49 1. DISCONNECT SHAPER FROM POWER SOURCE. IMPORTANT: The fence halves (A) Fig. 48, should be adjusted endwise so the opening at the spindle is never more than is required to clear the cutter. 2. To adjust the fence halves (A) Fig. 48 endwise, l...

20 Fig. 56 4. Loosen thumb screws on guard mounting bracket (P) Fig. 56, and adjust spring clamp (N) so it will provideinward pressure on workpiece; then tighten thumbscrews. NOTE: Thumb screws on guard mounting bracket (R) Fig. 56, can be loosened to permitextension of guard assembly. WARNING: TURN...

21 SHAPING WITH COLLARS AND STARTING PIN When shaping with collars and starting pin, the following rules must always be followed for good workand safety in operation. Fig. 60 Fig. 61 Fig. 62 Fig. 63 Fig. 64 Fig. 65 Fig. 66 1. Collars MUST be smooth and free of all gum or other substances. 2. The edg...

22 Fig. 67 Fig. 68 Fig. 69 Fig. 70 Fig. 71 STARTING PIN 1. Your machine is supplied with a tapered starting pin (A) Fig. 67, which is used as a support when starting thecut. The starting pin (A) is placed on one of the taperedholes (B) in the table. 2. Fig. 68, illustrates starting pin (A) placed in...

For Two-Speed Heavy DutyWood Shaper No. 50-273 Mobile Base. For H.D. Shaper. 22 Lbs. No. 43-348 Safety Ring Guard . For added safety and convenience on curved and circularedge shaping operations. Complete withmounting bracket. 9 Lbs. No. 43-188 Sliding Shaper Jig . Provides greater cutting accuracy ...

27 Printed in U.S.A. PARTS, SERVICE OR WARRANTY ASSISTANCE All Delta Machines and accessories are manufactured to high quality standards and are servicedby a network of Porter-Cable/Delta Factory Service Centers and Delta Authorized ServiceStations. To obtain additional information regarding your De...