DCS BE1-30AG-N - Manuals

5 SAFETY AND WARNINGS ! WARNING! Hot Surface Hazard Failure to follow this advice may result in fire, burns, scalds or personal injury. • Accessible parts may become hot during use.• When in use, do not touch the burner, grate, or immediate surrounding area as these areas become extremely hot. Clean...

6 SAFETY AND WARNINGS WARNING! To reduce the risk of fire, injury to persons or damage when using the appliance, follow the important safety instructions listed below. Read all the guidance before using the appliance. Do not use an outdoor cooking gas appliance for purposes other than intended. Serv...

7 SAFETY AND WARNINGS z z Do not store a full LP tank in direct sunlight. z z After a period of storage or non-use, the appliance should be checked for gas leaks, deterioration, proper assembly, and burner obstructions before use. General Use z z This appliance is not intended to be installed in or ...

8 SAFETY AND WARNINGS Gas requirements z z This appliance can be used with any brand of 20lb LP gas tank provided it is compatible with a proper retention device (not supplied). z z The LP gas cylinder must be: z z Designed for use with a Type 1 system only. z z Constructed and marked in accordance ...

9 z z Ensure the installer has completed the final checklist in the installation guide. z z Read this guide, taking special note of the safety and warnings section. z z Remove all packaging and dispose of it responsibly. Recycle items that you can. Grill Features 1 Control dials 2 Dual-sided grates ...

10 LIGHTING INSTRUCTIONS Push in and hold the selected dial for 2 seconds before turning to SEAR . Hold for 5 seconds to light the selected burner. If burner does not light in 5 seconds, turn dial back to OFF and wait 5 minutes before trying again. This will allow any accumulated gas to dissipate. 2...

11 Manual lighting If the burner will not light after several attempts, the burner can be manually lit. If you have attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. Hold a match over the hole located on the top left for burner on the left, or the...

12 1 USING THE GRILL Light the grill burners following the lighting instructions and preheat.Place food on the grill and cook to the desired level. You can adjust the heat setting during cooking if needed. 2 Using the grill When finished Turn control dial to OFF and shut the main gas supply. Allow t...

13 USING THE GRILL W SHAPED GRATE RADIUS GRATE Chicken Lobster Steaks Shrimp Bread Scallops Sausages Flat breads Dual-sided grates The dual-sided grate provides cooking options for food of varying textures. One side has a W-shaped surface that creates nice sear lines for steaks, chicken, chops and r...

14 LEAK TESTING 1 2 Prepare soap solution by combining one part liquid detergent and one part water. Pour into a spray bottle. Ensure all control valves are in the OFF position before turning the gas supply ON . Check all connections from the supply line or LP cylinder by applying the solution aroun...

15 BURNER ADJUSTMENT Flames should be blue and stable with no yellow tips, excessive noise or lifting (Note: LP units may have some yellow tipping). If any of these conditions exist, check the air shutter and burner ports are clear. If cleaning these does not improve performance, the air shutter can...

16 The valves on the grill feature an adjustable low setting. Due to fluctuations in gas pressure, or heating value you may want to increase or decrease gas flow in the low position. If the gas type has been converted from natural to LP or vice-versa, the low flame setting must be reviewed and adjus...

17 CARE AND CLEANING Regulator and hose replacement The pressure regulator and hose assembly supplied with the unit must be used. If replacements are needed, contact customer care at dcsappliances.com. Resetting the flow control Failure to follow the steps in the order shown may cause the Flow Limit...

18 Removing the burners for cleaning CARE AND CLEANING 3 Use a screw driver to open the bracket slot at the rear of the unit 2 1 Ensure the grill is OFF and cool. Remove the grill grates, then lift out the radiant tray. Press the bracket down while pulling the burner back and up. This should remove ...

19 CARE AND CLEANING Burner alignment 3⁄8 ” MIN REMOVE DRIP PAN TO VIEW CONNECTION Ensure the air shutters are not misaligned from their original position. Lower the rear of the burner into the cutouts on the support channel at the rear of the burner box. Ensure it is level and does not rock. Light ...

20 TROUBLESHOOTING If there is a problem with your grill, please check the following before contacting your local Fisher & Paykel trained and supported service technician or DCS Customer Care Centre. PROBLEM POSSIBLE CAUSES WHAT TO DO The grill won't light when the ignition is pushed There is no...

21 WARRANTY AND SERVICE Before you call for service or assistance Refer to the installation instructions and your user guide and check that: z z Your product is correctly installed. z z You are familiar with its normal operation. z z Model number (can be found on the inside, right side panel behind ...

U S C A 5 9 2 07 3 A 1 1 .1 9 © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any t...