Page 2 - Prepare for setup; Unpack your printer.; Connect the parallel cable; Use a parallel cable that supports bidirectional
1 Prepare for setup 1 Unpack your printer. 2 Remove all packing material from the printer. Print cartridges User’s Guide Power supply Software on CD Getting Started booklet 2 Connect the parallel cable 2a... to the printer 1 Use a parallel cable that supports bidirectional communication (IEEE 1284-c...
Page 3 - Make sure your computer is turned off.; Plug in your printer; a. Connect both ends of the; Connect the power supply to the printer.
2b... to the computer 1 Make sure your computer is turned off. 2 Connect the parallel cable to the computer. Make sure you tighten the screws. 3 Plug in your printer 3a. Connect both ends of the power supply 1 Connect the power supply to the printer. 2 If your power supply has a power cord attached ...
Page 4 - Install the print cartridges; a. Raise the front cover
3b. Is the Power light on? If the Power light is on, continue with step 4.If not, check your connections. Power light 4 Install the print cartridges 4a. Raise the front cover When you raise the front cover, the print cartridge carrier moves to the loading position.
Page 5 - b. Unpack the cartridges; Remove each new print cartridge from its packaging.; c. Insert the cartridges
4b. Unpack the cartridges 1 Remove each new print cartridge from its packaging. 2 Remove the sticker and the transparent tape covering the gold area on the cartridges. Tape Sticker Do not touch the gold contact area 4c. Insert the cartridges Colorcartridge Blackcartridge
Page 6 - Push back on the cartridges until they; snap securely; Load Paper; a. Prepare for loading
4d. Snap the cartridges into place 1 Push back on the cartridges until they snap securely into place. If the print cartridges move loosely in the carrier, they are not locked into place. Make sure the cartridges snap into place. 2 Close the front cover. SNAP SNAP 5 Load Paper 5a. Prepare for loading...
Page 8 - Install the printer software
6 Install the printer software If you are using Windows 3.1 or 3.11, or you need to obtain driver diskettes, see the appendix of the User’s Guide for installation information. If you are using Windows 95, 98, or NT 4.0 follow these steps: 1 Make sure your computer is on, and Windows is running. IMPO...
Page 9 - Compaq Customer Support Center
Follow these instructions only if the Compaq IJ750 screen shown on the previous page does not appear after a few moments: 1 From the Start menu, choose Run. 2 In the Open: text box, type the letter of your CD-ROM drive, followed by :\setup (for example, d:\setup), then click OK. 3 Follow the instruc...