Cisco WS-X6066-SLB-S-K9 - Manuals

9 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Environmental and System Requirements RJ-45 Connector The RJ-45 connector, which is covered by a removable plate, is used to connect a management station device or a test device. This connector is used by f...

10 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Environmental and System Requirements System Requirements Before you install the CSM-S in the Catalyst 6500 series switch, make sure that the switch meets the hardware and software requirements listed in t...

11 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Installing the CSM-S Software Requirements Caution The CSM-S release is not supported by the Catalyst operating system. Table 4 lists the software versions for the CSM-S. Software Compatibility The minimum...

12 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Installing the CSM-S Preparing to Install the CSM-S Before installing the CSM-S, make sure that the following items are available: • Catalyst 6500 series switch chassis • Management station that is availab...

13 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Installing the CSM-S • Slot 1 is reserved for the supervisor engine. • Slot 2 can be used for a redundant supervisor engine if the supervisor engine in slot 1 fails. • If a redundant supervisor engine is n...

14 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Installing the CSM-S Step 6 If the slot from which you removed the module is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain proper airflow through the chassi...

20 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Verifying the Installation Figure 7 Ejector Lever Closure in a Vertical Slot Chassis e. Tighten the two captive installation screws on the module. Note Make sure that the ejector levers are fully closed be...

21 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Related Documentation To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch Cisco IOS Software Co...

24 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Obtaining Documentation Obtaining Documentation Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical assistance and other technical...

25 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Documentation Feedback You can order Cisco documentation in these ways: • Registered Cisco.com users (Cisco direct customers) can order Cisco product documentation from the Ordering tool: http://www.cisco....

26 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Obtaining Technical Assistance Tip We encourage you to use Pretty Good Privacy (PGP) or a compatible product to encrypt any sensitive information that you send to Cisco. PSIRT can work from encrypted infor...

27 Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note 78-16856-01 Obtaining Additional Publications and Information Submitting a Service Request Using the online TAC Service Request Tool is the fastest way to open S3 and S4 service requests. (S3 and S4 service requests a...