Page 2 - Overview
2 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Overview Overview The GBIC is a hot-swappable input/output device that plugs into a Gigabit Ethernet port, linking themodule port with the fiber-optic network. There are two physical GBIC models available; one modelhas a locking hand...
Page 4 - Specifications
4 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Overview Specifications GBIC specifications are listed in Table 3. GBIC transmitter power and receiver sensitivity values arelisted in Table 4. Port Cabling Specifications Table 5 provides cabling specifications for the GBICs that yo...
Page 6 - Safety Overview
6 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Safety Overview Safety Overview Safety warnings appear throughout this publication in procedures that, if performed incorrectly, mayharm you. A warning symbol precedes each warning statement. Warning This warning symbol means danger....
Page 8 - Required Tools; Installing the GBIC; Installing a GBIC with Clips
8 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Required Tools Warning Ultimate disposal of this product should be handled according to all national laws andregulations. Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Donot directly touc...
Page 10 - Installing a GBIC with a Handle; Removing a GBIC
10 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Removing a GBIC Installing a GBIC with a Handle To install a GBIC that has a handle, follow these steps: Step 1 Remove the GBIC from its protective packaging. Step 2 Check the label on the GBIC to verify that the GBIC is the correct...
Page 11 - Removing a GBIC with Clips; Standards Compliance Specifications; FCC Class A Compliance
11 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Standards Compliance Specifications Removing a GBIC with Clips If you are removing a GBIC that has clips, follow these steps: Step 1 Disconnect the network fiber-optic cable from the GBIC SC-type connector. Step 2 Release the GBIC f...
Page 12 - Class 1 Laser Compliance; Translated Safety Warnings; Safety Information Referral Warning
12 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings You can determine whether your equipment is causing interference by turning it off. If the interferencestops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipmen...
Page 13 - Qualified Personnel Warning
13 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings Qualified Personnel Warning Warnung Warnhinweis Bevor Sie das System installieren, in Betrieb setzen oder warten, lesenSie die Anleitung zur Standortvorbereitung und Sicherheitshinweise . Dieses Handbuch e...
Page 14 - Class 1 Laser Product Warning
14 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings Class 1 Laser Product Warning Advarsel Bare opplært og kvalifisert personell skal foreta installasjoner, utskiftninger ellerservice på dette utstyret. Aviso Apenas pessoal treinado e qualificado deve ser a...
Page 15 - Invisible Laser Radiation Warning
15 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings Invisible Laser Radiation Warning Warning Because invisible laser radiation may be emitted from the aperture of the port when nocable is connected, avoid exposure to laser radiation and do not stare into o...
Page 16 - Product Disposal Warning
16 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings Product Disposal Warning Warning Ultimate disposal of this product should be handled according to all national laws andregulations. Waarschuwing Het uiteindelijke wegruimen van dit product dient te geschie...
Page 17 - Wrist Strap Warning
17 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Translated Safety Warnings Wrist Strap Warning Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card.Do not directly touch the backplane with your hand or any metal tool, or you couldshock yourse...
Page 18 - Related Documentation; Obtaining Documentation; World Wide Web
18 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Related Documentation Related Documentation For more detailed installation and configuration information, refer to these publications: • Site Preparation and Safety Guide • Catalyst 4003 and 4006 Switch Installation Guide • Catalyst...
Page 19 - Documentation Feedback; Obtaining Technical Assistance; Technical Assistance Center
19 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Obtaining Technical Assistance Documentation Feedback If you are reading Cisco product documentation on the World Wide Web, you can submit technicalcomments electronically. Click Feedback in the toolbar and select Documentation. Aft...
Page 20 - Contacting TAC by Using the Cisco TAC Website; Contacting TAC by Telephone
20 Gigabit Interface Converter Installation Note 78-5399-03 Rev. A0 Obtaining Technical Assistance Contacting TAC by Using the Cisco TAC Website If you have a priority level 3 (P3) or priority level 4 (P4) problem, contact TAC by going to the TACwebsite: http://www.cisco.com/tac P3 and P4 level prob...