Cisco VC-825 - Manuals

Cisco VC-825 – Manual in PDF format online.

Manuals:

Manual

Manual Cisco VC-825

Summary

Page 2 - configuration guide

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-826 Cisco IOS Voice, Video, and Fax Configuration Guide Hoot and holler is used in these various industries as a way to provide a one-to-many or many-to-many conferencing service for voice communications. In the past, hoot and holler ...

Page 3 - Configuring Interactive Voice; Current Hoot and Holler Implementations; Traditional hoot and holler networks (see; Carrier-provided audio bridging; Cisco Hoot and Holler over IP Overview

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-827 Cisco IOS Voice, Video, and Fax Configuration Guide For further information about interactive voice response (IVR), refer to Configuring Interactive Voice Response for Cisco Access Platforms. Current Hoot and Holler Implementation...

Page 4 - equipment over an IP network.; Voice Multicasting

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-828 Cisco IOS Voice, Video, and Fax Configuration Guide This dynamic sharing of bandwidth is even more compelling with hoot and holler than with a toll-bypass application because some hoot circuits may be active for an hour or two for...

Page 5 - Configuring Voice Ports; session protocol multicast; Content Manager

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-829 Cisco IOS Voice, Video, and Fax Configuration Guide You can connect voice multicasting telephones to routers in the following ways: • Connect a four-wire E&M telephone, which has no dial and is always off-hook, directly to an ...

Page 6 - Note; Interactive Voice Response; Command Reference; Migration Strategy

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-830 Cisco IOS Voice, Video, and Fax Configuration Guide Note IP/TV support for Cisco hoot and holler over IP uses only G.711 u-law (mu-law) encoding. IP/TV supports one audio stream for Cisco hoot and holler over IP. IP/TV does not su...

Page 7 - Technical Details of the Cisco Hoot and Holler over IP Solution; Cisco IOS IP and IP Routing Configuration Guid

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-831 Cisco IOS Voice, Video, and Fax Configuration Guide The highly segmented nature of existing hoot and holler networks can be leveraged in the migration from legacy hoot technology to Cisco hoot and holler over IP. A small segment o...

Page 8 - IP Multicast and DSP Arbitration and Mixing; IPmc; Bandwidth Planning; Bandwidth management techniques.

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-832 Cisco IOS Voice, Video, and Fax Configuration Guide IP Multicast and DSP Arbitration and Mixing When deploying Cisco hoot and holler over IP, first consider how the voice streams are going to be mixed and how they will be distribu...

Page 9 - Codecs; In; Codec; Uncompressed

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-833 Cisco IOS Voice, Video, and Fax Configuration Guide Codecs By default, Cisco IOS sends all VoIP traffic (media, using RTP) at a rate of 50 packets per second. The packets include not only the voice sample, but also an IP, User Dat...

Page 10 - Cisco IOS; bytes; This can be configured as in the following E&M port example:; Virtual Interface

Cisco Hoot and Holler over IP Hoot and Holler over IP Overview VC-834 Cisco IOS Voice, Video, and Fax Configuration Guide More information on cRTP may be found in the “Quality of Service Overview” chapter of the Cisco IOS Quality of Service Solutions Configuration Guide at the following URL: http://...

Page 11 - In this example, the digits in the; connection trunk; string match the destination pattern of the VoIP; Cisco Hoot and Holler over IP Restrictions; IP/TV does not support the mixing of audio streams.; Configuration Tasks; Configuring Multicast Routing, page 836

Cisco Hoot and Holler over IP Cisco Hoot and Holler over IP Restrictions VC-835 Cisco IOS Voice, Video, and Fax Configuration Guide With traditional VoIP usages of connection trunk, the call is mapped to a remote router/gateway, and all the H.323 signaling is handled dynamically when the trunk is es...

Page 12 - Configuring Multicast Routing; Enables multicast routing.; Command

Cisco Hoot and Holler over IP Configuration Tasks VC-836 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring Multicast Routing To enable multicast routing, use the following commands beginning in global configuration mode: Configuring the Virtual Interface To configure the virtual interf...

Page 13 - Configuring VoIP Dial Peers; tag

Cisco Hoot and Holler over IP Configuration Tasks VC-837 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring VoIP Dial Peers To configure the VoIP dial peers on the router, use the following commands beginning in global configuration mode: Command Purpose Step 1 Router(config)# dial-peer...

Page 15 - Configuring E&M Voice Ports; show; seconds; trunk; digits

Cisco Hoot and Holler over IP Configuration Tasks VC-839 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring E&M Voice Ports To configure E&M voice ports, use the following commands beginning in global configuration mode: Step 4 Router(config-dial-peer)# session target Assigns th...

Page 16 - immediate

Cisco Hoot and Holler over IP Configuration Tasks VC-840 Cisco IOS Voice, Video, and Fax Configuration Guide Step 9 Router(config-voice-port)# operation { 2-wire | 4-wire } Specifies the cabling scheme for E&M ports. The 2-wire keyword is the default. (Choose 4-wire operation for the hoot and ho...

Page 17 - Configuring for Receive Only Mode; word

Cisco Hoot and Holler over IP Configuration Tasks VC-841 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring for Receive Only Mode To configure Cisco hoot and holler over IP as receive-only mode, use the following commands beginning in global configuration mode: Step 14 Router(config-voi...

Page 18 - Configuring Voice Ports in High-Density Voice Network Modules; disabled; slot; high

Cisco Hoot and Holler over IP Configuration Tasks VC-842 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring Relevant Interface (Serial/Ethernet) To configure either the serial or Ethernet interface, use the following commands beginning in global configuration mode: Configuring Voice Por...

Page 19 - Configuration Examples; Voice Multicasting over an Ethernet LAN, page 844; digit

Cisco Hoot and Holler over IP Configuration Examples VC-843 Cisco IOS Voice, Video, and Fax Configuration Guide Configuration Examples This section provides a series of configuration examples to help you become familiar with voice multicasting. These examples also show how to ensure that each config...

Page 20 - Voice Multicasting over an Ethernet LAN; VIC

Cisco Hoot and Holler over IP Configuration Examples VC-844 Cisco IOS Voice, Video, and Fax Configuration Guide Voice Multicasting over an Ethernet LAN Figure 134 shows the simplest configuration for voice multicasting over an Ethernet LAN. Two routers are connected to each other over the Ethernet L...

Page 21 - Configuring the Second Router; session target; Verifying the Configuration; show call active voice

Cisco Hoot and Holler over IP Configuration Examples VC-845 Cisco IOS Voice, Video, and Fax Configuration Guide Configuring the Second Router In router Costello ( Figure 134 ), the E&M phone is connected to voice port 3/1/1. Router Costello uses the same configuration as Abbott, except for the f...

Page 22 - High-Density Voice Modules; Dial-Peer Configuration; The following commands show how to configure a dial peer with tag

Cisco Hoot and Holler over IP Configuration Examples VC-846 Cisco IOS Voice, Video, and Fax Configuration Guide High-Density Voice Modules A multiflex trunk interface card in a high-density voice network module requires special voice-port configuration. The card must be configured first as is shown ...

Page 23 - show config; Tips; This session target must be the same for all routers in a session.; Ethernet Configuration; Voice Multicasting over a WAN

Cisco Hoot and Holler over IP Configuration Examples VC-847 Cisco IOS Voice, Video, and Fax Configuration Guide session target ipv4:237.111.0.0:22222 ip precedence 5 codec g711ulaw ! Note The configuration for the codec g711ulaw in the above configuration is not necessary—the default codec of g729r8...

Page 24 - Quality of Service; priority; command, the first number is the audio port. The second number

Cisco Hoot and Holler over IP Configuration Examples VC-848 Cisco IOS Voice, Video, and Fax Configuration Guide Quality of Service Voice traffic is much more sensitive to timing variations than data traffic. For good voice performance, configure your data network so that voice packets are not lost o...

Page 25 - connection

Cisco Hoot and Holler over IP Configuration Examples VC-849 Cisco IOS Voice, Video, and Fax Configuration Guide Cisco Hoot and Holler over IP with Ethernet Topology (Two Hoot Groups) The following figure illustrates Cisco hoot and holler over IP being used with an Ethernet topology: Figure 135 Cisco...

Page 27 - command and the; plar

Cisco Hoot and Holler over IP Configuration Examples VC-851 Cisco IOS Voice, Video, and Fax Configuration Guide Note If you want to join the hoot and holler session directly without having to dial any session numbers, use the connection command and the plar keyword, followed by the multicast-session...