Cisco Jackscrew - Manuals - manualsarea.com

Page 2 - Obtaining Technical Assistance; Date you received the Cisco 7000; Product Overview

2Jackscrew Installation Instructions (for EIP Ports) Obtaining Technical Assistance This document contains instructions for replacing the slide-type connector locks thatare standard on Cisco 7000 EIP ports with jackscrews so that you can connect cableswith thumbscrews to the ports. If you encounter ...

Page 3 - Figure 1

Jackscrew Installation Instructions (for EIP Ports) 3 Figure 1 Ethernet Connector Locks, Slide-Type and Jackscrew-Type The EIP is the 2, 4, or 6-port high-speed Ethernet interface processor for the Cisco 7000router. The EIP and other interface processors (IPs) slide into slots in the rear of therout...

Page 4 - Figure 3; Prerequisites; Required Tools; /16-inch nut driver to tighten the jackscrews

4Jackscrew Installation Instructions (for EIP Ports) ■ Transmit—Lights when frames are being transmitted. When frames aretransmitted, the Receive LED also lights up because valid traffic is being sent onthe network. ■ Receive—Lights when frames are being received. It indicates that valid traffic isb...

Page 5 - Required Parts; jackscrews; Preventing Electrostatic Discharge (ESD) Damage; Following are guidelines for preventing ESD damage:

Jackscrew Installation Instructions (for EIP Ports) 5 Required Parts The following parts are included in each jackscrew replacement kit. Because the holesin the EIP are threaded, you need only two lock washers and two jackscrews for eachport. Discard the extra flat washers and hex nuts included in t...

Page 6 - measurement should be within the range of 1 and 10 Mohms.; Installation; Shutting Down Interfaces

6Jackscrew Installation Instructions (for EIP Ports) Note: For safety, periodically check the resistance value of the antistatic strap. The measurement should be within the range of 1 and 10 Mohms. Installation The following installation process describes the procedure for shutting down theinterface...

Page 7 - Removing the Slide Lock; Figure 5

Jackscrew Installation Instructions (for EIP Ports) 7 After you have replaced the connector locks, reenable the interfaces by entering thecommand no shutdown, as shown in the following partial example. interface ethernet 1/1 no shutdown ^Z You can display the current state of an individual Ethernet ...

Page 8 - Installing the Screw-Type Lock; Figure 6

8Jackscrew Installation Instructions (for EIP Ports) Step 4: Repeat steps 2 and 3 for all addition ports that require jackscrews. Step 5: Place the removed brackets and slotted screws aside; you can discard themafter the jackscrews are installed, and the installation is complete. Installing the Scre...

Page 9 - Checking the Installation; Connect network interface cables to the EIP ports.

Jackscrew Installation Instructions (for EIP Ports) 9 Checking the Installation To check the interfaces, you will connect network interface cables to the EIP ports,reenable any interfaces you shut down, if any, then check the LEDs and consoledisplays to verify the status of the interfaces. Step 1: C...