Chief WMA2S - Manuals

Chief WMA2S – Manual in PDF format online.

Manuals:

Manual

Manual Chief WMA2S

Summary

Page 2 - Installation Instructions; DISCLAIMER

WMA2S Installation Instructions 2 DISCLAIMER Milestone AV Technologies and its affiliated corporations andsubsidiaries (collectively "Milestone"), intend to make thismanual accurate and complete. However, Milestone makes noclaim that the information contained herein covers all details,condit...

Page 3 - LEGEND

Installation Instructions WMA2S 3 LEGEND Tighten Fastener Apretar elemento de fijación Befestigungsteil festziehen Apertar fixador Serrare il fissaggio Bevestiging vastdraaien Serrez les fixations Loosen Fastener Aflojar elemento de fijación Befestigungsteil lösen Desapertar fixador Allentare il fis...

Page 4 - TOOLS REQUIRED FOR INSTALLATION

WMA2S Installation Instructions 4 TOOLS REQUIRED FOR INSTALLATION PARTS 1/2" (12.7mm) steel stud #2 7/32" (5.6mm) wood 2" x 4" stud 3/8" (10mm) concrete and concrete block 5/32" (security) (included) 1/2" (12.7mm) 3/16" A (1)[WMA2S Assembly] B (1) [Mounting bracket] E...

Page 5 - Site Requirements; Drywall

Installation Instructions WMA2S 5 Site Requirements WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for installation of display mounts onto asteel stud structure. If the structur...

Page 6 - ASSEMBLY AND INSTALLATION; Installing Mounting Bracket; ELECTRICAL SHOCK HAZARD! CUTTING; Concrete or Concrete Block; If installing to a concrete or concrete; Determine mounting location on wall.; Figure 1; Bracket Width; section for details.; Figure 3; Wood studs

WMA2S Installation Instructions 6 ASSEMBLY AND INSTALLATION The WMA2S dual stud wall mount accessory can be mountedto concrete, concrete block, 2" x 4" wood studs (16" on center)or steel studs. It can be mounted to studs up to 16" apart. Installing Mounting Bracket WARNING: ELECTRICA...

Page 7 - See

Installation Instructions WMA2S 7 5. Install four 5/16 x 2-1/2" hex head lag screws (E) throughfour 5/16" washers (F), holes of mounting bracket and intodrilled holes. (See Figure 4) Figure 4 Steel StudsIMPORTANT ! : See Site Requirements section before proceeding with Steel Studs installati...

Page 8 - Figure 9; Installation to Mounting Bracket

WMA2S Installation Instructions 8 10. Place wall bracket over anchors and align mounting holes in mounting bracket with holes in anchors. (See Figure 9) 11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (H) through 1/4" washer (G), corresponding mounting hole on mountingbracket (B) and int...

Page 9 - Turn; clockwise; to raise mounting level.; counterclockwise; Installing Mount Covers; or

Installation Instructions WMA2S 9 4. Loosen two bolts on either side of pitch adjustment screw.(See Figure 13) 5. Adjust pitch adjustment screw until mount is at desired pitchlevel. • Turn clockwise to raise mounting level. • Turn counterclockwise to lower mounting level. (See Figure 13) 6. Tighten ...

Page 10 - PROJECTOR INSTALLATION; Exceeding the weight capacity can result in; The maximum length column that can; Removing Mount Covers

WMA2S Installation Instructions 10 PROJECTOR INSTALLATION WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is theinstaller’s responsibility to make sure the combined weightattached to the wall mount accessory up to (and including)the attached co...

Page 11 - Cables may be routed from below and up wall bracket; Routing Cables from Below (Steps 5 and 6); Proceed to Step 7; cable clips x 4

Installation Instructions WMA2S 11 4. Remove cable management cover (if necessary) fromWMA2S arm. (See Figure 19) Figure 19 NOTE: Cables may be routed from below and up wall bracket channel, or from above and down behind and into wallmount. • Routing Cables from Below (Steps 5 and 6) 5. Open cable c...

Page 12 - Cables can be tied to inside of projector’s front; Installation of Mounting Bracket Covers; If security screws are going to be used, use the security; Security Screw Installation; (Mount accessory arm not shown for clarity)

WMA2S Installation Instructions 12 8. Route cables through cover mount, WMA2S arm and intocolumn. (See Figure 23) Figure 23 9. (Optional) Cables can be tied to inside of projector’s front cover using cable ties (not included). Route cables nearfront cover and wrap cable tie through slots on front co...

Page 13 - Adjustments; Bracket Width Adjustment

Installation Instructions WMA2S 13 2. Secure wall bracket top covers (C) to wall bracket arms byinstalling four #8-32 x 1/2" Phillips pan machine screws (T)through holes in covers and wall bracket. (See Figure 27) 3. Place wall bracket bottom covers (D) over bottom of eachwall bracket arm. (See ...

Page 14 - Extension Adjustment; Install mount covers to the mount following instructions in

WMA2S Installation Instructions 14 7. Install mount covers to the mount following instructions in Installing Mount Covers section. Extension Adjustment 1. Loosen two bolts holding stop bracket in place on undersideof WMA2S mount. (See Figure 31) 2. Adjust mount to desired extension length. (See Figu...

Page 15 - Remove column from WMA2S according to; Stop bracket

Installation Instructions WMA2S 15 2. Install eight #8-32 x 1/2" button head security screws (M)into holes in wall bracket covers. (See Figure 34) Figure 34 3. Remove two #8-32 x 1/2" Phillips pan machine screws (T)holding mount covers on WMA2S arm. (See Figure 35) 4. Install two #8-32 x 1/2...

Page 16 - Repeat Steps 8-9 for remaining three bolts, one bolt at a

WMA2S Installation Instructions 16 8. Remove one of four bolts from adapter plate. (See Figure 38) 9. Install one 1/4-20 x 3/4" button head security screw (L) intohole vacated by removing bolt in Step 8 and into plasticspacer. (See Figure 39) 10. Repeat Steps 8-9 for remaining three bolts, one b...

Page 20 - Europe; Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands; Asia Pacific; 011 Milestone AV Technologies, a

USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands P +31 (0)40 2668620 F +31 (0)40 2668615 Asia Pacific A Office No. 1 on 12/F, Shatin Galleria18-24 Shan Mei Street Fota...